Computer Simulation of Aluminum Conductors Drawn in High Speed

Abstract:

Drawing speed is one important process in production over-head line, deform 3d software is used to simulate the drawing process. The distribution of stress-strain and temperature in different drawing speed with die angle and friction coefficient was investigated. The results shows that the aluminum conductors can be used in high speed drawing when die angle, drawing speed and frication coefficient of first pass is about11~13 degrees, 4~6m/s and 0.08~0.10 respectively, the uniformity of stress-strain and temperature is better for producing good quality over-head wires with high cold-drawing speed.

• Periodical: Advanced Materials Research (Volumes 834-836)
• Pages: 1567-1570
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.834-836.1567
• Online since: October 2013
• Authors: Ming Xue Yang, Jing Tian Luan, Tian Guo Zhou*, Xue Fei Zhang
• Keywords: Deform 3D, Drawing Die Angle, Drawing Speed, Friction Coefficient (FC)

References

[1] B. Liu, Q. Zheng, P. Dang and W. Zeng: Electric Wire &Cable Vol. 4(2012), p.10.

[2] T.G. Zhou, J.L. Wen and Y.B. Chen: Chinese Journal of Materials Research Vol. 19(3)(2005), p.331.

[3] T.G. Zhou, Z.Y. Jiang, J.L. Wen, H. Li and A.K. Tieu: Materials Science and Engineering A Vol. 485(2008), p.108.

[4] R.X. Wang and X.J. Lu, J.R. Yang: Tooling Technology Vol. 4(2012), P. 49.

[5] X.Q. Sun and C. S. Deng: Science Technology and Engineering Vol. 11(8)(2011), p.1709.

[6] Z. Q. Huang: Electric Wire & Cable Vol. 4(2007), p.5.

[7] G.Z. Quan , J. Zhou, Y. Tong : Material of Mechanical Engineering Vol. 7 (2008), p.70.

[8] X.J. Yang, F.H. Sun: Nan Yang Science and Technology College Journal Vol. 3 (2009), p.68.

[9] X.Q. Sun, L.H. Yang: Casting Forging Welding Vol. 40 (9)(2011) , p.20.

[10] X.B. Lin: Die Technology Vol. 3(2000), p.75.