Design of the Face Structure of the Grinding-Driller Based on Deform-3D

Ping Kuan Zhang; Wang Lu Sun; Hui Lin Wang

doi:10.4028/www.scientific.net/AMR.893.664

Paper Titles

Influence of the Intermediate Annealing on Deformation Ability of the Cold Rolled Ring
p.644

Effect on the Grinding Performance by the Different Elements of the Auxiliary Material
p.649

Influence of Minimum Quantity Lubrication on Cutting Force and Tool Wear during Machining of GH4169
p.653

Synthesis of Mesoporous Molecular Sieve MCM-41 and its Adsorption Behavior for Rhodamine B
p.658

Design of the Face Structure of the Grinding-Driller Based on Deform-3D
p.664

Calculation Method for Interference Value in Metal Joining Structure
p.668

Simulation of HDIs Behaviors in the Plasma Arc Cold Hearth Melting Process
p.672

Fabrication of Polymer Micro-Patterns by Transient Thermolithography with Thickness Control
p.679

Numerical Study on Normal Stress Distributions in a Single-Lap Adhesive Joint
p.685

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 893Design of the Face Structure of the...

Design of the Face Structure of the Grinding-Driller Based on Deform-3D

Abstract:

The process of grinding-drill is simulated by using of deform-3D. it is analyzed that deferent face structure of grinding-driller influences grinding-drill process. The reasonable taper vertex angle and amount of eccentric of the grinding-driller are gained by means of the smallest axial force & torque & lower cutting temperature. So that the reasonable face structure of grinding-driller will be gained.

You might also be interested in these eBooks

Advanced Materials and Engineering Materials III

View Preview

Info:

Periodical:

Advanced Materials Research (Volume 893)

Pages:

664-667

DOI:

https://doi.org/10.4028/www.scientific.net/AMR.893.664

Citation:

Cite this paper

Online since:

February 2014

Authors:

Ping Kuan Zhang*, Wang Lu Sun, Hui Lin Wang

Keywords:

Grinding-Drill Structure, Mini-Hole Machining, Simulation

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

Citation:

* - Corresponding Author

References

[1] W.M. Zeng Z.C. Li,X.P. Xu,Z.J. Pei, J,D. Liu and J. Pi. Experimntal investigation of intermittent rotary ultrasonic machining[J], Key Engineering Materials, (2008).

DOI: 10.4028/www.scientific.net/kem.359-360.425

Google Scholar

[2] Xu Lifu, Chen Qian, Zhou Li, Huang Shutao. Limited element analyzed on the stiffness & strength of different ditch type diamond bit[J]. Tool Engineering, 2010, 10: 38～42.

Google Scholar

[3] Shi Zhihui, Liu Gang. The method of drilling parameters using in the machining center[J]. Tool Engineering, 2009, 7: 61～63.

Google Scholar

[4] Xu Liangqing. Explore on the machining of small diameter deep hole[J]. Modern Manufacturing Technology and Equipment，2011, 1: 51～52.

Google Scholar

[5] Zhou Liping. Study on the calculate of the drilling force based on FEM[J]. Journal of Xihua University(Natural Science Edition), 2009. 5: 1～2.

Google Scholar