A Finite Element Analysis for the Characteristics of Cutting Parameters in 3D Oblique Milling Process

Guo Hua Qin; S.Q. Xin; Dong Lu; Yi Ming Rong

doi:10.4028/www.scientific.net/AMR.97-101.3010

Paper Titles

Nonlinear Numerical Optimization Design Applied to Wall-Thickness of Welding T Shaped Connecting HDPE Tube
p.2991

On the Control System for Blank-Holder Force in Deep Drawing Based on Self-Tuning Fuzzy-PID Controller
p.2995

A Parallel Numerical Study of Transient Heat Transfer and Fluid Flow of Weld Pool during Laser Keyhole Welding
p.3001

Temperature and Stress Analysis in Micro-Cutting of Ti-6Al-4V and Al7050-T6
p.3005

A Finite Element Analysis for the Characteristics of Cutting Parameters in 3D Oblique Milling Process
p.3010

Simulation and Experimental Investigation for the End Milling Process of 7075-T7451 Aluminum Alloy
p.3014

Research on Machining Simulation System for Optical Free-Form Surfaces
p.3020

The Algorithm of Acoustic Location for Boiler Tube Leakage
p.3024

Simulation of Compressive Strength of SiC Foam
p.3028

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 97-101A Finite Element Analysis for the Characteristics...

A Finite Element Analysis for the Characteristics of Cutting Parameters in 3D Oblique Milling Process

Abstract:

In the field of aeronautical and astronautical manufacturing, milling is a basic machining process by which a surface is generated by progressive chip removal. Therefore, this paper reports a complete procedure of the finite element model for the 3D oblique milling process using the commercial software package ABAQUS. Effect of various parameters on cutting forces is mainly discussed. The model correctly exhibits the observed transition from small to large force with increasing cutting speed and cutting depth.