Development of G-Code Based on PMAC in CNC Machining Center

Abstract:

PMAC motion controllers serve not only as a receiver of the orders from CNC systems of many kinds, but also as a controller of the motion of machine tools’ axles. With G83 as an example, a code commonly seen in the processing cycle of deep holes in CNC machining centers, it is advisable to come up with a method to write a special set of subprograms to invoke PMAC motion controllers with the application of G-code. Based on the method, case programing and machining simulation can be launched. Experiments justify that the method obtained can realize the compiling of fixed cycles with the use of G-code and, in turn, boast substantial significance in the development of open CNC processing machine tools.

• Periodical: Advanced Materials Research (Volumes 989-994)
• Pages: 3290-3293
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.989-994.3290
• Online since: July 2014
• Authors: Chuan Chuan Cao, Qi Han Sun, San Peng Deng*, Yu Zhou
• Keywords: Fanuc, G-Code, PMAC Motion Controller

References

[1] Delta Tau clipper Motion Control Card（OL）(2009).

[2] FANUC 0i-MB Operating Instructions. Beijing FANUC company(2008).

[3] Chen Xi Ling: Using a macro program optimization CNC milling of deep drilling, urban construction Industry Press( 2011).

[4] Rockets three axis simulator-based study of PMAC (D) Harbin: Harbin Engineering University(2008).

[5] Turbo PMAC (PMAC2) Software Reference Manual (Chinese version) (2011).