HF Transport Coefficients in Polymers Used for Microelectronic Applications

Abstract:

In order to better understand the sorption and outgassing mechanism of gases in relation to wafers containers (FOUP), we have measured HF gas transport coefficients for different FOUP polymers. Gas sorption is governed by surface adsorption, followed by diffusion and solubility. Cross contamination between FOUP and wafer occurs when polymers outgas contaminants into the surrounding environment. Diffusion is the key parameter to understanding cross contamination within the FOUP environment. In this work, we present the transport coefficients obtained for gaseous HF at cleanroom conditions (Patm, 21 ± 2°C & 40% RH) using the sorption kinetic method, based on Fick’s law, for thin films (<80μm) of polycarbonate (PC), polyetherimide (PEI) and a low absorbing polymer named Entegris Barrier Material (EBM) that constitute FOUPs. The resulting kinetic curves show Fick’s behavior, where obtained HF diffusion coefficients are between 3.7 X10^-10 and 42 x10^-12 cm2/s and are significantly lower than diffusion coefficients obtained for H₂O using a gas permeation method. Nevertheless, the similar order of magnitude between the HF and the H₂O permeability coefficients obtained by the two methods validates the sorption kinetic method. Finally, the obtained coefficients were used in numerical simulation in order to forecast polymer behavior.

• Periodical: Defect and Diffusion Forum (Volume 367)
• Pages: 68-76
• DOI: https://doi.org/10.4028/www.scientific.net/DDF.367.68
• Online since: April 2016
• Authors: P. González-Aguirre, Hervé Fontaine, C. Beitia, R. Pastorello, J. Ohlsen, J. Lundgren
• Keywords: Fick’s Law, FOUP Polymers, HF Transport Coefficients, Numerical Simulation, Sorption Kinetic

References

[1] SEMI International Standards. F21-1102 - Classification of Airborne Molecular Contaminant Levels in Clean Environments. available at www. semi. org September (2002).

[2] T. Kamoshima, Y. Fujii, T. Noguchi, T. Saeki, Y. Takata, H. Ochi, A. Koiwa. Controlling ambient gas in slot-to-slot space inside FOUP to suppress Cu-loss after dual damascene patterning, IEEE Trans. Semicon. Manufact., vol. 21.

DOI: 10.1109/tsm.2008.2005343

[3] H. Fontaine, H. Feldis, A. Danel, S. Cetre, C. Ailhas. Impact of the volatile acid contaminants on Cu interconnects electrical performances ECS Transactions, 25 (5), (2009), 79-86.

DOI: 10.1149/1.3202638

[4] T.Q. Nguyen, H. Fontaine, Y. Borde, V. Jacob. Identification and quantification of FOUP molecular contaminants inducing defects in integrated circuits manufacturing Microelectronic Engineering, 105, (2013), 124-129.

DOI: 10.1016/j.mee.2012.04.008

[5] International Technology Roadmap for Semiconductors (ITRS), Yield Enhancement, 2013. (www. itrs. net).

[6] H. Fontaine S. Cetre, M. Villerot, A. Danel. Study of the volatile organic contaminants absorption and their reversible outgassing by FOUPs Solid State Phenomena, 145-146, (2009), 143-146.

DOI: 10.4028/www.scientific.net/ssp.145-146.143

[7] H. Fontaine and M. Veillerot. Plastic containers contamination by volatile acids: accumulation, release and transfer to Cu-surfaces during wafers storage Solid State Phenomena, 134, (2008), 251-254.

DOI: 10.4028/www.scientific.net/ssp.134.251

[8] P. González-Aguirre, H. Fontaine, C. Beitia, J. Ohlsen, J. Lundgren, P. Lee. A comparative study of the HF sorption and outgassing ability of different Entegris FOUP platforms and materials. Microelectronic Engineering, 105 (2013), 113-188.

DOI: 10.1016/j.mee.2012.12.005

[9] B. Flaconnèche, J. Martin, M.H. Klopffer, Transport Properties of Gases in Polymers : Experimental Methods. Oil & Gas Science and Tec. Vol 56, (2001) No. 3, 245-259.

DOI: 10.2516/ogst:2001022

[10] H. Fontaine Y. Borde, C. Brych, A. Danel. Characterization of the HCl absorption & outgassing mechanism by FOUP's polymers. ECS Transactions, 25, 5, (2009), 139-146.

DOI: 10.1149/1.3202646

[11] S. I. Moon, C. W. Extrand, Humidity Rise after Purge in Micro-Environments, Advanced Semiconductor Manufacturing Conference, (2012), 308-310.

DOI: 10.1109/asmc.2012.6212917

[12] N. Santatriniaina, J. Deseure, T. Q. Nguyen, H. Fontaine, C. Beitia, L. Rakotomanana. Mathematical Modeling of the AMCs Cross-Contamination Removal in the FOUPs: Finite Element Formulation and Application in FOUP's Decontamination, International Journal of Mathematical, Computational Science and Engineering, Vol 8, No 4, (2014).

DOI: 10.14419/ijamr.v3i3.2829

[13] P. González-Aguirre, H. Fontaine, C. Beitia, J. Ohlsen, J. Lundgren, P. Control of HF volatile contamination in FOUP environment by advanced polymers and clean gas purge. Solid State Phenomena Vol. 219 (2015), 247-250.

DOI: 10.4028/www.scientific.net/ssp.219.247