Inline Semisolid Rolling of Al-5%Mg Strip Cast Using Twin Roll Caster

Toshio Haga; Hiizu Ochi; Hiroshi Fuse; Hisaki Watari; Shinichi Nishida

doi:10.4028/p-2jLzzv

Paper Titles

Preface

Inline Semisolid Rolling of Al-5%Mg Strip Cast Using Twin Roll Caster
p.3

Semisolid Forging of Al-10%Mg
p.9

Microstructure on Inner Surface of Cell Walls inside Aluminum Alloy Foam Fabricated via Semi-Solid Route
p.15

Study on Film Morphology of Liquid Droplet Evaporation in Confined Space
p.27

Voltage-Induced Director Orientations in IPS-Liquid Crystal Cells with Different Electrode Structures
p.33

Optical Absorption and Bandgap Modulation in Diamond-Like Carbon Films for Anti-Reflection
p.39

Effect of Channel Length Variation on the Electrical Conductivity of Passivated Back-Gated Graphene Field-Effect Transistor (GFET) Using Silvaco TCAD Tools
p.47

The Heat Dissipation Effect of Liquid Cooling Heat Sink Based on Triply Periodic Minimal Surface Structure
p.57

HomeKey Engineering MaterialsKey Engineering Materials Vol. 1059Inline Semisolid Rolling of Al-5%Mg Strip Cast...

Inline Semisolid Rolling of Al-5%Mg Strip Cast Using Twin Roll Caster

Abstract:

In Al-5%Mg strip cast using a high-speed twin roll caster, surface cracks can occur and these cracks remain even after cold rolling. In order to eliminate cracks, cast strip was directly rolled in a semisolid state. Casting speed of the strip was 30 m/min. Cast semisolid strip was rolled at various reductions. Semisolid high-speed roll casting could be achieved using a copper roll and small roll load. Semisolid rolled strip was cold rolled down to 1 mm. The surface condition, microstructure and tensile strength of the cast and rolled strips were evaluated. Mechanical properties of the semisolid and cold rolled strip were compared to those of hot rolled and cold rolled strip, and those of only cold rolled strip.