Thermal Simulation and Experimental Study on Tire Building Machine Hot Knife

Abstract:

To tire building machine hot knife , for example, the heat set temperature, flank contact temperature and flank edge temperature were determined and analysis, finite element method for heat transfer simulation calculations. After experimental verification, simulation and prediction of flank and edge temperature consistent with the measured data. Experiments show that the temperature can effectively control the heat source to control the temperature of a specific area, so not for the excess heat to meet the processing requirements to achieve efficient use of energy.

• Periodical: Key Engineering Materials (Volume 501)
• Pages: 489-494
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.501.489
• Online since: January 2012
• Authors: Yue Tang, Ling Qian Meng
• Keywords: Contact Surface Temperature, Finite Element (FE) Simulation, Hot Knife, Numerical Simulation, Temperature Field

References

[1] Wei Jiang, etc.The New Tire Compound Piece Cutter System Design.Modern Rubber Technology, Vol.35, No.4(2009), pp.34-39.

[2] Wen Quan Tao ed. Heat Transfer. Northwestern University Press, 2006.

[3] Peng Fuquan, et al. Mechanical Engineering Materials Manual . Beijing: Mechanical Industry Press. 1990.

[4] Zhang Jingjing, etc. A Use of Finite Element Heat Transfer Simulation of the Cutting Tip Point Accurate Temperature Measurement. Tool Technology, Vol. 44, No.1(2010) ,pp.85-87

[5] Yue Tang, Yongping Dai. Experimental Research on the Hot Knife's Temperature in Radial Tire Building Machine .Advanced Polymer Processing. 2010，pp.119-123

[6] Dai, ed. Transport Phenomena in Polymer Processing. Beijing: China Petrochemical Press. 1999.