Material Model Identification for DC04 Based on the Numerical Modelling of the Polycrystalline Microstructure and Experimental Data

Abstract:

Sheet-bulk-metal forming processes require an accurate material model which is derived in this contribution. The microscopic model is based on a simulation of a real microstructure. A validation on the macroscopical scale is performed through the reproduction of the experimentally calculated yield surface based on the homogenised structural response of a corresponding deformed representative volume element (RVE). The microstructural material model is also compared with a macroscopical phenomenological model based on logarithmic strains. The homogenised microscopic model and the phenomenological macroscopic model are in good agreement with the evolution of the stresses and strains obtained during the experiments.

• Periodical: Key Engineering Materials (Volumes 504-506)
• Pages: 993-998
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.504-506.993
• Online since: February 2012
• Authors: Eva Lehmann, Stefan Schmaltz, Sandrine Germain, Dennis Faßmann, Christoph Weber, Stefan Löhnert, Mirko Schaper, Friedrich Wilhelm Bach, Paul Steinmann, Kai Willner, Peter Wriggers
• Keywords: Anisotropic Finite Elastoplasticity, Homogenization, Materials Modelling, Sheet-Bulk-Metal Forming

References

This article has no references.