Preface
Study on Factors which Make CBN Insert can Turn S45C Steel Have Surface Roughness Less than Ra 0.4
p.3
p.3
Weldability of Similar and Different Metallic Materials
p.8
p.8
Computer Simulation and Analysis of the Parameters of the Drawing Process of Thin Wire from the Alloy Pd-5Ni
p.13
p.13
Study of the Influence of Conditions of Combined Casting and Rolling-Extruding and Two-Stage Annealing on the Structure and Properties of Semi-Finished Electrical Products from an Al–Zr System Alloy
p.19
p.19
Computer Modeling and Analysis of the Energy-Power Process Parameters of the Combined Machining of Alloys Al-Mg System
p.25
p.25
Investigation of Side-Dam Plate in Single-Wheel Caster for Casting Rods
p.31
p.31
Forming of Small Projection on Roll-Cast A356 Strip by Cold Rolling and Small Groove on PET Plate Using A356 Die
p.37
p.37
600 mm-Wide Strip Casting Using Single Roll Caster Equipped with Scraper
p.43
p.43
Preface
Abstract:
You might also be interested in these eBooks
Info:
Periodical:
Key Engineering Materials (Volume 805)
Online since:
June 2019
Сopyright:
© 2019 Trans Tech Publications Ltd. All Rights Reserved
Share: