Roofing Materials Based on Synthetic Rubbers with Additives - Waste Products

Abstract:

The paper uses waste from the production of synthetic rubbers, industry, various clays for effective ways to solve the socio-economic and environmental problems of preserving natural resources and preventing environmental pollution. The construction materials industry faces the most important task-the search for non-deficit raw materials that allow partially or completely eliminate expensive conditioned polymers, rubbers and obtain cheaper mastic roofing materials while maintaining their high physical, mechanical and operational properties. Thermomechanical curves of composite materials based on synthetic rubbers with additives were studied. It is shown that the softening of samples of roofing materials No. 325 and No. 326 begins at , 20 % deformation is achieved, respectively, at – (No. 325) and + (No. 326), a sharp increase in deformation is observed, respectively, with a loss of strength: 40 % (No. 325) and 20 % (No. 326). Based on these materials, reinforced mastic roofs have been developed, which have low values of crack resistance. The coefficient of water resistance depends on the base, i.e. the reinforcing materials.

• Periodical: Key Engineering Materials (Volume 869)
• Pages: 449-455
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.869.449
• Online since: October 2020
• Authors: Malik N. Abdikarimov*, Raushan Kh. Turgumbayeva, Saule Sagintaeva, Gulim Bergenzhanova, Ainura Rasmukhametova, Shalhar Nauryzbayeva
• Keywords: Butyl Rubber, Clays, Epoxy Resin, Non-Woven Fabric, Roofing Materials, Siloxane Rubber, Thermomechanical Curves

References

[1] V.A. Lomovskoy, et al., Methods for studying the relaxation phenomena of polymers in a highly elastic state (dynamic methods), Educational and methodical manual, Ministry of education and science of the Russian Federation, Moscow, (2010).

[2] A.N. Trufanov, Investigation of thermomechanical properties of thin films of UV-cured films, in: XII all-Russian Congress on fundamental problems of theoretical and applied mechanics. 4 (2019) 207-209.

[3] N.E. Kochkina, N.D. Lukin, N.R. Andreev, Investigation of the kinetics of thermal destruction and strength characteristics of nanocomposite materials based on Na-montmorillonite starch obtained in a vibrating mill, Success of modern science and education. 5 (2016) 174-182.

[4] M.V. Korshunov, Ya.D. Samuilov, A.Ya. Samuilov, Chemical recycling of polycarbonates in the medium of diatomic alcohols, Bulletin of the Technological University. 21 (2017) 48-52.

[5] E.V. Alifanov, Polymer roofing and waterproofing materials with a high content of rubber recycling products that do not require vulcanization, in: Abstract of the dissertation for the degree of candidate of technical Sciences, Moscow state M.V. Lomonosov Academy of fine chemical technology, Moscow, (2004).

[6] A.N. Gaidadin, I.P. Petryuk, Analysis of methods for determining the kinetic parameters of thermodestruction of polymers based on dynamic thermogravimetry data, in: Polymer materials of reduced combustibility proceedings of the VI International conference. (2011)7-8.

[7] A.N. Gaidadin, I.P. Petryuk, Ya.V. Zarudny, Analysis of methods for calculating kinetic parameters of thermal destruction for polyolefin-based thermoplastics, The news of Volgograd state technical University. 75 (2011) 106-109.

[8] V.V. Mamaev, Determination of kinetic parameters of thermal destruction of combustible materials, Scientific Bulletin of niigd Respirator. 53 (2016) 47-56.

[9] S.I. Builo, V.V. Belozerov, Yu.V. Prus, Combined thermogravimetric and acoustic - emission diagnostics of the stages of thermodestruction of substances and materials. 3 (2008) 71-74.

DOI: 10.1134/s1061830908030078

[10] M.A. Haskov, D.A. Melnikov, A.I. Gulyaev, L.A. Dementieva, Using thermal analysis methods to study the process and products of microphase separation in systems based on thermosetting oligomers, in: Role of fundamental research in the implementation of Strategic directions for the development of materials and technologies for their processing for the period up to 2030 materials of the V all-Russian scientific and technical conference. Federal state unitary enterprise «All-Russian research Institute of aviation materials». (2019) 352-362.

DOI: 10.18577/2307-6046-2017-0-10-6-6

[11] N.T. Kakhramanov, R.V. Gurbanova, Yu.N. Kakhramanly, State of the problem of obtaining, research and application of organosilicon polymers, Eurasian Union of scientists. 27 (2016) 112-118.

[12] N.R. Prokopchuk, Investigation of the thermal stability of polymers by the method of derivatography, News of the Academy of Sciences of the Belarusian SSR. Series of chemical Sciences. 4 (1984) 119-121.

[13] V.M. Shapovalov, V.P. Dubodel, I.I. Zlotnikov, S.Yu. Hrishchanovich, O.E. Рantyukhov, M.N. Dolgacheva, V.V. Taletsky, Development and research of bituminous polymer compositions using secondary polymers, Mining mechanics and mechanical engineering. 4 (2016) 54-61.

[14] T.A. Akopova, V.S. Osipchik, Yu.V. Olikhova, T.P. Kravchenko, L.H. Nguyen, Modification of the epoxy composition by oligosylsesquioxanes, Plastic. 1-2 (2015) 41-44.

[15] L.B. Kandyrin, E.V. Taranenko, P.N. Timoshkov, V.N. Kuleznev, Properties of epoxy compositions modified with organosilicon esters, News of higher educational institutions. Series: Chemistry and chemical technology. 50 (2007) 36-41.

[16] M.N. Abdikarimov, A.Sh. Kusainova, K.K. Makhmutova, I.Ya. Sadchikov, Thermomechanical research of roofing materials and adhesive mastics, Light industry of Kazakhstan-Almaty. 4 (1995) 40-47.

[17] M.N. Abdikarimov, Z.D. Abdykadyrova, A.S. Kussainov, I.I. Mustaev, The Influence of fillers on physico-mechanical and thermomechanical properties of roofing materials, in: Abstracts scientific and technical conf. «Composite polymer materials. Processing and application in the national economy». Izhevsk. (1990). 27.

[18] M.N. Abdikarimov, Z.D. Abdikadyrova, A.Sh. Kusainova, Reinforced mastic roofing materials based on substandard production waste and research of their operational properties, in: Abstracts respubl. nauchno-tekhn. conf. «Rational use of industrial waste with the use of environmentally friendly technologies in the textile, leather and footwear industries of light industry». Dzhambul, Alma-Atа. (1990) 69-70.

[19] M.N. Abdikarimov, B.A. Zhubanov, R.H. Turgumbayeva, Sh.A. Sabyrbaeva, S.M. Baibolov, Investigation of the influence of natural clays and metallurgical waste on the physical and mechanical properties of roofing materials based on synthetic rubbers, in: Abstracts International Symposium «Chemical science as the basis for the development of the chemical industry of Kazakhstan in the XXI century, dedicated to the 100th anniversary of the birth of academician A.B. Bekturov». Almaty. (2001) 116-117.