Effect of Scanning Interval on Polishing Effect of S136D Die Steel

Abstract:

Laser polishing technology plays an increasingly important role in the material processing technology.In order to study the influence of scanning interval on the polishing effect of S136D die steel, the single factor experiment method is used in this paper. The continuous fiber laser is used to carry out many laser polishing experiments and the influence of laser scanning interval on the surface morphology of S136D die steel is analyzed.The results show that the surface roughness of polished samples decreases first and then increases with the of scanning interval. When the scanning interval is in the range of 0.03-0.1mm, the surface roughness of samples is relatively flat, and the lowest surface roughness can be reduced to 0.781μm, and the reduction rate of surface roughness can reach 90.2%.

• Periodical: Materials Science Forum (Volume 1020)
• Pages: 55-59
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.1020.55
• Online since: February 2021
• Authors: Hao Zhou, Zhen Yu Zhao*, Hou Ming Zhou, Kai Li, Jing Cheng Jin
• Keywords: Laser, Scanning Interval, Surface Roughness

References

[1] André Temmler, Kurt Graichen, Johannes Donath. Laser Polishing in Medical Engineering[J]. Laser Technik Journal.2010, Vol.7(No.2):53-57.

DOI: 10.1002/latj.201090028

[2] J.A. Ramos-Grez, D.L. Bourell.Reducing surface roughness of metallic freeform-fabricated parts using non-tactile finishing methods[J]. International journal of materials & product technology, 2004, 21(4): 297-316.

DOI: 10.1504/ijmpt.2004.004944

[3] Frank E. Pfefferkorn, Neil A. Duffie, Justin D. Morrow; et al.Effect of beam diameter on pulsed laser polishing of S7 tool steel[J].CIRP Annals - Manufacturing Technology.2014,63(1):237-240.

DOI: 10.1016/j.cirp.2014.03.055

[4] Chang-Shuo Chang,Ting-Hsuan Chen,Tse-Chang Li, et al.Influence of laser beam fluence on surface quality, microstructure, mechanical properties, and tribological results for laser polishing of SKD61 tool steel[J].Journal of Materials Processing Technology,2016,229:22-35.

DOI: 10.1016/j.jmatprotec.2015.09.009

[5] Chang-Shuo Chang, Chen-Kuei Chung,Jen-Fin Lin.Surface quality, microstructure, mechanical properties and tribological results of the SKD 61 tool steel with prior heat treatment affected by the deposited energy of continuous wave laser micro-polishing[J].Journal of Materials Processing Technology. 2016,234:177-194.

DOI: 10.1016/j.jmatprotec.2016.03.024

[6] Obeidi MA,McCarthy E,O'Connell B, et al.Laser Polishing of Additive Manufactured 316L Stainless Steel Synthesized by Selective Laser Melting.[J].Materials (Basel, Switzerland). 2019,12(6).

DOI: 10.3390/ma12060991