Mechanical Alloying and Sintering of Ti-10Wt.% Mg Powders

Christopher Machio; D. Nyabadza; Hilda Kundai Chikwanda; M. Phasha; V.M. Sibanda

doi:10.4028/www.scientific.net/MSF.618-619.105

Paper Titles

High Pressure Coolant Application in Milling Titanium
p.89

Simulation of Flow Field and Particle Trajectory in EB Cold Hearth Melting Process
p.93

Research on Titanium Alloys with High Toughness and High Damage Tolerance
p.97

Studies on Hydrogen Embrittlement of Ti-2Al-2.5Zr Alloy
p.101

Mechanical Alloying and Sintering of Ti-10Wt.% Mg Powders
p.105

Mechanical Properties of Porous Stainless Steel Metal Fibre Media
p.109

Quantitative Analysis of Alpha Morphology Changes of Ti-17 Alloy with a Lamellar Starting Microstructure
p.113

Machining of Light Metals: Challenges for Surface Engineering
p.117

Aero-Engine Titanium from Alloys to Composites
p.127

HomeMaterials Science ForumMaterials Science Forum Vols. 618-619Mechanical Alloying and Sintering of Ti-10Wt.% Mg...

Mechanical Alloying and Sintering of Ti-10Wt.% Mg Powders

Abstract:

A Ti-10wt.%Mg powder alloy has been produced by mechanical alloying. Elemental powders of Ti and Mg were ball milled in a Zoz-Simoloyer CM01 for 16 and 20 hours under argon. Mechanical alloying was followed by XRD, SEM and particle size analysis. Test specimens of the milled powders were produced by cold compaction and sintering (under argon). The milling resulted into a fcc TiMg solid solution for both milling durations. Sintering leads to a partial decomposition of the fcc TiMg to hcp TiMg and Ti.