Effect of Melt Treatment on Forming and Brazing Characteristics of 4343/3003/4343 Aluminum Clad Sheet

Je Sik Shin; Sung Ho Chang

doi:10.4028/www.scientific.net/MSF.695.457

Paper Titles

Investigation of Thermal Sprayed Stainless Steel/WC-12wt%Co Nanocomposite Coatings
p.441

Ultrasound-Enhanced Electrochemical Preparation of Atomic Oxidants
p.445

Effect of Annealing on Ag-Doped Submicron Silica Powder Prepared with Modified Stöber Method
p.449

Influencing of Ca-Based Sorbent on the Sulfur Retention
p.453

Effect of Melt Treatment on Forming and Brazing Characteristics of 4343/3003/4343 Aluminum Clad Sheet
p.457

Comparative Study on the Effects of Different Molecular Weight Polyethylene Powders in Soil
p.461

Study on Microstructure and Impact Strength of Nano-SiO₂ Toughened Epoxy Resin Composites
p.465

Surface and Mechanical Properties of Cellulose Micro-Fiber Reinforced Recycle Polyethylene Film
p.469

Pulsed Electric Current Sintering of the Al₂O₃ - 15wt% ZrO₂ Nanocomposites with 3wt% of Different Solid Lubricants
p.473

HomeMaterials Science ForumMaterials Science Forum Vol. 695Effect of Melt Treatment on Forming and Brazing...

Effect of Melt Treatment on Forming and Brazing Characteristics of 4343/3003/4343 Aluminum Clad Sheet

Abstract:

In this study, it was aimed to investigate the effects of grain refining of 3003 core alloy on forming and brazing characteristics of 4343/3003/4343 aluminum clad sheet. Ti inoculation level was changed up to 0.1wt% by adding Al-10Ti master alloy into 3003 aluminum melt as grain refiner. The three-layer aluminum clad sheets of 0.7 mm thickness were fabricated by hot roll bonding process. The forming and brazing characteristics were evaluated by measuring FLD (forming limit diagram), bonding strength and sagging resistance.