Effect of Electrolyte on the Surface Smoothness Obtained by Electropolishing of Stainless Steel

Abstract:

Electropolishing is a surface finishing process of metals and alloys that enhances brilliant surface finishes with low surface roughness values. The most widely used electrolytes for the electropolishing of stainless steel are varying concentrations of phosphoric and sulphuric acid, and occasionally additives such as chromic acid. The objective of this study was to assess the performance of three commonly used industrial electrolytes in terms of the surface finish of electropolished stainless steel AISI 316L. Each electrolyte had varying sulphuric-phosphoric acid combinations with or without chromic acid. The following electropolishing conditions were assessed: current density, bath temperature, electropolishing time, and initial surface texture. The results revealed that adding chromic acid to the electrolyte did not significantly enhance surface finish, and electropolishing ranges were quite similar for all three electrolytes.

• Periodical: Materials Science Forum (Volume 713)
• Pages: 55-60
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.713.55
• Online since: February 2012
• Authors: M. Hernando, Pedro José Núñez, Eustaquio García Plaza, R. Trujillo
• Keywords: Electrolyte, Electropolishing, Optimum Conditions, Roughness Surface, Surface Finish

References

[1] C. Lin and C. Hu: Electrochimica Acta Vol. 53 (2008), pp.3356-3363.

[2] C. Lin, C. Hu and T. Lee: Surf. and Coat. Tech. Vol. 204 (2009), pp.448-454.

[3] S.J. Lee and J.J. Lai: J. of Mat. Proc. Tech. Vol. 140 (2003), pp.206-210.

[4] S.E. Ziemniak, M. Hanson and P.C. Sander: Corrosion Sci. Vol. 50 (2008), pp.2465-2477.

[5] A.M. Awad, N.A. Abdel Ghany and T.M. Dahy: App. Surf. Sci. Vol. 256 (2010), pp.4370-4375.

[6] P.J. Núñez, E. García-Plaza, A.R. Martín, R. Trujillo and C. De la Cruz, in: Methodology for optimizing the electropolishing of stainless steel AISI 316L combining criteria of surface finish and dimensional precision, Proceedings of American Institute of Physics Vol. 1181 (2009).

DOI: 10.1063/1.3273622

[7] R. Trujillo, P.J. Núñez, A.R. Martín, E.M. Beamud, C. De la Cruz, in: Influencia de los parámetros de control del procesos de pulido electroquímico sobre el alisamiento superficial, Proceedings of 2nd MESIC, Madrid (2007).

[8] P.S. Kao and H. Hocheng: J. of Mat. Proc. Tech. Vol. 140 (2003), pp.255-259.

[9] H. Ramasawmy and L. Bluntç: Int. J. of Mach. Tools and Manuf. Vol. 42 (2002), pp.1129-1133.

[10] ISO 4287, Geometrical Product Specifications (GPS) - Surface texture: Profile method - Terms, definitions and surface texture parameters (1997).

DOI: 10.3403/30398213