For Libraries For Publication Open Access Downloads About Us Contact Us
Paper Titles
Effect of (Ni,Mo) and (W,Ti)C on the Microstructure and Mechanical Properties of TiB2 Ceramic Tool Materials
p.233
A Computer-Based Intelligent System for Automatic Tool Selection
p.238
Experimental Study on Orthogonal Cutting of Ti6Al4V with Surface Micro-Groove Textured Cutting Tool
p.243
Experimental Study on Nano-TiAlN Coated Carbide Tools in Turning Austenitic Stainless Steel
p.247
Measurement Method of HSK Tool Holder’s Unbalance in HSM
p.252
Development of Al2O3/TiC/CaF2 Graded Self-Lubricating Ceramic Cutting Tool Materials
p.258
Modal Experiment and Analysis of HSK Tool-Holder and Thin-Disk Cutter
p.264
Analysis of Vibration Signals Caused by Unbalance of the HSK Shank
p.269
The Heat Performance Analysis of HSK Shrink Toolholder
p.275

Measurement Method of HSK Tool Holder’s Unbalance in HSM

Article Preview

Abstract:

The hazards of HSK toolholders caused by unbalance vibration are described The vibration information can be more accurately extracted by choosing the appropriate method of measuring unbalance and using FFT transform to reconstruct wavelet signal. Finally, the HSK tool holders unbalance measurement software module diagram are shown. This way can be a good basis for scientific research and the development of the HSK integrated measurement system.

You might also be interested in these eBooks
High Speed Machining V View Preview

Info:

Periodical:

Materials Science Forum (Volume 723)

Pages:

252-257

DOI:

https://doi.org/10.4028/www.scientific.net/MSF.723.252

Citation:

Cite this paper

Online since:

June 2012

Authors:

Jun Jian Yu, Shu Lin Wang, Jian Chen, Gui Cheng Wang

Keywords:

HSK Shank, Signal Processing, Unbalance

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2012 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

References

[1] H. Schulz: Proc International Conference on High Speed Machining, 31(2) (2004), p.1—20

Google Scholar

[2] G.C. Wang S.L. Wang, G.Q.D: Tooling System for High Speed Machining (National Defense Industry Publishing, Beijing 2008).

Google Scholar

[3] T. Aovama, I. Inasaki: Ann. CIRP 50(1) (2001), p.281—284

Google Scholar

[4] Z. Wang. Study on static and dynamic performanceof HSK too1ing system and its simulation [D] (Jiangsu University, Zhenjiang 2003)

Google Scholar

[5] M. Tsutsumi: Int. J. JapanSoc. Prec. Eng. 29(4) (1995), p.301—306

Google Scholar

[6] G.C. Wang, S.L. Wang. Mater. Sci. Forum Vol. 505~507 (2006), p.469~474

Google Scholar

[7] Y.L. Ping: J. Chongqing Univ. (2003)

Google Scholar

[8] L. J: J. Vib. Eng. (1995)

Google Scholar

© 2025 Trans Tech Publications Ltd. All rights are reserved, including those for text and data mining, AI training, and similar technologies. For open access content, terms of the Creative Commons licensing CC-BY are applied.
Scientific.Net is a registered trademark of Trans Tech Publications Ltd.