Microstructure and Properties of Hot Compacted Al-12 wt% Zn-3 wt% Mg-1.5 wt% Cu Melt Spun Ribbons

Article Preview

Abstract:

The alloys Al-12 wt % Zn-3 wt % Mg-1.5 wt % Cu with addition of Zr were melt spun and then hot pressed under 600 MPa pressure at 380 °C. Refinement of the microstructure and reduction of the volume fraction of the η (MgZn2) phase was observed in melt spun ribbon, as compared to the mould cast alloys. Good quality samples without pores and cracks obtained by hot pressing were composed of grains of size 0.2-0.5 µm. The particles of the η phase enriched in Zn, Mg and Cu were homogenously distributed in the matrix, while a few nanometres large precipitates of magnesium oxide were located at grain boundaries. Plate like precipitates of metastable h¢ phase appear after ageing at 120 °C and lead to microhardness increase up to about 195 HV as compared to 145 HV in pressed sample. Hot pressed ribbons showed compression strength of about 450 MPa which increased up to 630 MPa after ageing.

You might also be interested in these eBooks

Info:

Periodical:

Solid State Phenomena (Volume 186)

Pages:

247-250

Citation:

Online since:

March 2012

Export:

Price:

Permissions CCC:

Permissions PLS:

Сopyright:

© 2012 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

[1] I.N. Fridlyander: Metal Science and Heat Treatment 45 (2003), p.341.

Google Scholar

[2] Y.L. Wu, F.H. Froes, A. Alvarez, C.G. Li and J. Liu: Materials & Design 18 (1997), p.211.

Google Scholar

[3] H. Adachi, K. Osamura, S. Ochiai, J. Kusui and K. Yokoe: Scripta mater. 44 (2001), p.1489.

DOI: 10.1016/s1359-6462(01)00715-1

Google Scholar

[4] J. Kusui, K. Fujii, K. Yokoe, T. Yokote, K. Osamura, O. Kubota and H. Okuda: Mater. Sci. Forum 217-222 (1996), p.1823.

DOI: 10.4028/www.scientific.net/msf.217-222.1823

Google Scholar

[5] K.L. Kendig and D.B. Miracle: Acta mater. 50 (2002), p.4165.

Google Scholar

[6] P. Ochin: Arch. Metall. Mater. 49 (2004), p.753.

Google Scholar

[7] J.D. Robson and P.B. Prangnell: Acta mater. 49 (2001), p.599.

Google Scholar

[8] H. Adachi, K. Osamura, J. Kusi and S. Okaniwa: Mater. Sci. Forum 519-521 (2006), p.1479.

Google Scholar

[9] L. Lityńska-Dobrzyńska, J. Dutkiewicz, W. Maziarz and A. Góral: Materials Transaction, 52 (2011), p.309.

Google Scholar