CMT Robotized Welding of Thin-Walled Joints Made of 7xxx Series Aluminium Alloy

Janusz Adamiec; Janusz Rykała

doi:10.4028/www.scientific.net/SSP.211.31

Paper Titles

Proeutectic Crystallisation of AlSi17Cu5 Alloy after Overheating and Modification with Al-CuP Master Alloy
p.3

Effect of Overheating on the Mechanical and Plastic Properties of A390.0 Cast Alloy
p.9

Welding of Aluminium Alloy Thin Sheets Using Variable Polarity MIG Method
p.15

Effect of Ti Addition to Zn Filler Metal on Wettability and Reinforcement of Soldered Joint of Aluminum
p.23

CMT Robotized Welding of Thin-Walled Joints Made of 7xxx Series Aluminium Alloy
p.31

Effect of Electrode Negative Ratio in AC MIG Welding of Aluminium Alloy 6082 on the Microstructure and Properties of Heat Affected Zone
p.39

Hybrid Comopsites Shaped by Casting Methods
p.47

Fine Particle Reinforced Composites Obtained by Suspension Method
p.53

Assessment of the Deformation of Composites with Aluminum Matrix Designed for the Metal Forming
p.57

HomeSolid State PhenomenaSolid State Phenomena Vol. 211CMT Robotized Welding of Thin-Walled Joints Made...

CMT Robotized Welding of Thin-Walled Joints Made of 7xxx Series Aluminium Alloy

Abstract:

The article presents the course and the results of research on material and technological welding conditions of 7xxx aluminium alloy using low energy welding method (CMT) as well as discusses the properties of welded joints and the application fields of modern low energy welding devices for joining thin aluminium sheets.

You might also be interested in these eBooks

View Preview

Info:

Periodical:

Solid State Phenomena (Volume 211)

Pages:

31-38

DOI:

https://doi.org/10.4028/www.scientific.net/SSP.211.31

Citation:

Cite this paper

Online since:

November 2013

Authors:

Janusz Adamiec*, Janusz Rykała

Keywords:

Aluminium Alloy, Circle Path Test, CMT, Hot Cracking, Low Energy Welding, Microstructure Analysis

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

Citation:

* - Corresponding Author

References

[1] J. Adamiec, T. Pfeifer, J. Rykała, Modern methods of aluminum alloys welding", Solid St. Phenom. 176 (2011) 35-38.

DOI: 10.4028/www.scientific.net/ssp.176.35

Google Scholar

[2] J. Adamiec, T. Pfeifer, J. Rykała, CMT and MIG-Pulse robotized welding of thin-walled elements made of 6xxx and 2xxx series aluminium alloys, Solid St. Phenom. 191 (2012) 45-56.

DOI: 10.4028/www.scientific.net/ssp.191.45

Google Scholar

[3] C. Huang, S. Kou, Partially Melted Zone in Aluminium Welds: Solute Segregation and Mechanical Behavior, Welding Journal Supplement, (2001).

Google Scholar

[4] C. Huang, S. Kou, Liquation Cracking in Full-Penetration Al-Mg-Si Welds, Welding Journal, (2004).

Google Scholar