Numerical and Experimental Studies of Fluid Flow and Heat Transfer in a Model Experiment for Hydrothermal Growth

Article Preview

Abstract:

Understanding of the natural convection flow in hydrothermal autoclaves is essential for the control of the growth rate and the quality of the grown crystals. This paper presents an analysis of the natural convection fluid flow and heat transfer and show the comparison between simulation and experimental results for the experimental model in a small size autoclaves, fill with water. A numerical model based on finite volume method has been developed to simulate the heat transfer and fluid convection in the vessel. Results show that the flow will strongly affect the temperature distribution. It can be observed that in the upper region the liquid flows up in the middle of the vessel and flows down in lateral parts near the walls. The temperature difference between experimental and simulation results is less than 1 °C in the upper part and between 2 and 3 °C in the bottom part. Velocity measurements show a good qualitative agreement between simulation and experimental results. The value of the z-component of velocity along the symmetry axis slightly increase with the increases of temperature difference ΔT .

You might also be interested in these eBooks

Info:

Periodical:

Solid State Phenomena (Volume 254)

Pages:

237-242

Citation:

Online since:

August 2016

Export:

Price:

Permissions CCC:

Permissions PLS:

Сopyright:

© 2016 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

* - Corresponding Author

[1] V. Ranieri, S. Darracq, M. Cambon, J. Haines, O. Cambon, A. Largeteau, G. Demazeau, In situ X-ray absorption spectroscopy study of Si(1-x)GexO2 dissolution and germanium aqueous speciation under hydrothermal conditions. Inorg. Chem., 50 (2011).

DOI: 10.1021/ic201856p

Google Scholar

[2] V.A. Klipov, N.N. Shmakov, Influence of convective flow on the growth of synthetic quartz crystals, in: Proceedings of the 45th Annual Symposium on Frequency Control, IEEE, Los Angeles, CA, USA, 1991, p.29–36.

DOI: 10.1109/freq.1991.145884

Google Scholar

[3] K. Byrappa, Hydrothermal growth of crystals. In: Hurle DTJ (ed) Handbook of crystal growth. Elsevier Science B.V., North-Holland, 1994, p.465.

Google Scholar

[4] H. Li, E.A. Evans, G.X. Wang, Flow of solution in hydrothermal autoclaves with various aspect ratios. Journal of Crystal Growth 256 (2003) 146–155.

DOI: 10.1016/s0022-0248(03)01300-9

Google Scholar

[5] L.A. Gordienko, V.F. Miushov, V.E. Khadzhi, L.I. Tsinober, Sov. Phys. -Crystallogr. 14 (1969) 454-456.

Google Scholar

[6] R. Roy, O.F. Tuttle, Investigations under hydrothermal conditions. Physics and Chemistry of the Earth 1(1956) 138-180.

DOI: 10.1016/0079-1946(56)90008-8

Google Scholar

[7] H. Li, M.J. Braun, C. Xing, Fluid flow and heat transfer in a cylindrical model hydrothermal reactor, Journal of Crystal Growth 289 (2006) 207–216.

DOI: 10.1016/j.jcrysgro.2005.10.113

Google Scholar

[8] H. Li, M.J. Braun, E.A. Evan, G.X. Wan, G. Paudal, J. Miller, Natural Convection Flow Structure and Heat Transfer in a Model Hydrothermal Growth Reactor. Int. J. Heat Fluid Flow 26 (2005) 45-55.

DOI: 10.1016/j.ijheatfluidflow.2004.06.005

Google Scholar

[9] Y. Takeda, Measurement of velocity profile of mercury flow by ultrasound Doppler shift method. Nucl. Techn. 79 (1987) 120-124.

DOI: 10.13182/nt87-a16010

Google Scholar

[10] D. Brito, H.C. Nataf, P. Cardin, J. Aubert, J.P. Masson, Ultrasonic Doppler Velocimetry in liquid gallium. Exp. Fluids 31(2001) 653-663.

DOI: 10.1007/s003480100312

Google Scholar

[11] S. Eckert, G. Gerbeth, Velocity measurements in liquid sodium by means of ultrasound Doppler velocimetry, Exp. Fluids 32 (2002) 542-546.

DOI: 10.1007/s00348-001-0380-9

Google Scholar

[12] A. Leca, I. Prisecaru, Proprietati termofizice si termodinamice solide, lichide, gaze. Vol 1, (1994) Editura Tehnica Bucuresti.

Google Scholar

[13] D. Vizman, J. Friedrich, G. Müller, 3D time-dependent numerical study of the influence of the melt flow on the interface shape in a silicon ingot casting process. Journal of Crystal Growth, 303 (2007) 231-235.

DOI: 10.1016/j.jcrysgro.2006.11.317

Google Scholar

[14] D. Vizman, O. Gräbner, G. Müller, Three-dimensional numerical simulation of thermal convection in an industrial Czochralski melt: comparison to experimental results. J. Cryst. Growth, 233 (2001) 687–698.

DOI: 10.1016/s0022-0248(01)01633-5

Google Scholar

[15] D. Vizman, I. Nicoara , G. Müller, Effects of temperature asymmetry and tilting in the vertical Bridgman growth of semi-transparent crystals. J. Cryst. Growth, 212 (2000) 334-339.

DOI: 10.1016/s0022-0248(99)00867-2

Google Scholar