Search results

During the sensing process, the Fan-1 is ON, while the Fan-2 and Fan-3 are OFF.
Fig.1.
Schematic circuit of the whole system of e-nose Table 1.
References [1] X.
Erwanto, International Food Research Journal 19(2) (2012) 475-479 [4] J.

References [1] Correa, E.
C. and other, The effect of microstructure on abrasive wear of a Fe-Cr-C-Nb hardfacing alloy deposited by the open arc welding process, Surface & Coatings Technology, Tome: 276, P.: 479-484 [2] Gouveia, Ronny M., Silva, Francisco J.
Federation, IPC B23H 1/00, B23H 9/00.
Bul. №1, 2015 - 5 p
[8] Pat. for utility model RU 139667 U1, MPK B23R 6/00 V25N 1/00.

Bakar 1,a, F.
Eqs. (1)-(4) need to be solved subject to the boundary conditions U=V=0, θ=1 on the inner square; θ=0 on the outer square.
The density formulation, ρnf=1-φρf+φρs, the heat capacity, ρCpnf=1-φρCpf+φρCps, the thermal expansion coefficient, ρβnf=1-φρβf+φρβs, the effective viscosity, μnf=μf199.21φ2+4.62φ+1.0 the thermal conductivity, knf=kf125.62φ2+4.82φ+1.0 and the thermal diffusivity of the nanofluid, αnf=knfρCpnf.
References [1] S.
Campo, Effect of Nanofluid Variable Properties on Natural Convection in Enclosures, International Journal of Thermal Sciences 49 (2010) 479-491

Byeon 1,a, S.I.
(1) In actual plants, the mean size of globular carbide can be measured by nondestructive replication technique, and then it can be empirically correlated with the hardness reduction through the Eq. (1).
References [1] N.S.
Forum Vol. 475-479 (2005), p. 257 [4] J.W.
Vol. 1 (1970), p. 9 [10] J.W.

The test was on a electric vehicle and the parameters of this vehicle is shown in Table 1.
Table 1 Parameters of test vehicle Mass 1370kg Height of center of mass 0.569m Rolling resistance coefficient 0.019 Air resistance coefficient 0.3 Wheel base 2.5m Height of vehicle 1.503m Wheel radius 0.287m Front face area 1.746m2 Driving distance 150km Rated voltage 336V Rated speed 3000r/min Rated torque 64Nm The data was divided into two kinds, crowded condition and unobstructed condition, by the time period, and was processed into micro-trip. 50 micro-trips were got, including 18 in crowded condition and 32 in unobstructed condition.
So the cost of establishing a driving cycle is cut, and development cycle is reduced. 1. 2.
Reference [1]Zhang Shupei, Huang Xuan, Wang Guolin,et.
[9]WANG Zhenpo,YAO Limin,SUN Feng-chun.Preliminary Study on Evaluation System of Energy Consumption Economy[J].Journal of Beijing Institute of Technology,2005,25(6):479-482.

During the storm events, the ranges of COD, TSS, NH4+-N, TN and TP concentration were 6.0-38.5, 10-479.3, 8.5-51.4, 11.8-61.9 and 0.7-5.1mg/L, respectively.
Fig.1 shows that the concentrations varied obviously along with rainfall duration.
It was concluded that higher mean rainfall intensity caused a higher decrement rate [1][2].
Additionally, Fig. 1 displays concentrations reduced to the lowest at 20 min.
References [1] Jun Ho Lee, Ki Woong Bang: Water Res.

Namely, if the observed value is known, each is a numerical value to all belong to the class, then the stage k observed valuebelongs to the class probability and the stage k-1 the observed value can get the class [4].
During the process of intensive care, heart rate arrhythmia detection is a very important project; under the normal circumstances, the position of the human heart pacemaker is sinus node internal, that the formation of sinus heart rate, its specific is shown in Figure 1 [8,9].
Figure 1.
References [1] Li Qiao, Yu Mengsun.
Compute Bi01 Med, 2009, 34(6):479-93

JIT has become a focus in both business and academic circles for it can improve the efficiency of the supply chain[1].
Inventory time curve[9] under JIT supply mode is shown in figure 1.
References [1] Yan D，Carter C R, Dresner M E.
A JIT Lot - splitting Model for Supply Chain Management : Enhancing Buyer – supplier Linkage [J].Int.J.Production Economics,2003,86:1-10
Int.J.Production Economics,2008,113:470-479.

Introduction For Eurocode design specification, BS EN1993-1-3 [1] differentiates the member design between small deflection of compact section and large deflection of slender section with effective width method.
Fig. 1 shows the deformation of column flange.
References [1] British Standards Institution, Eurocode 3: Design of steel structures.
Applied Mechanics and Materials, vols. 479-480 (2014) pp. 1144-1148
Journal of Structural Engineering, Vol. 130:1 (2004) pp. 78-94

Constraint (3) expresses that =0 or 1 is the decision variable of the upper-level.
Numerical Experiments In the experiment of Gao[1], the potential links are 1-6, 5-10, 2-7, 6-11, 3-8 and 7-12.
Let the standard deviations of the random variables equal 1.
References [1] Z.Y.
Sun, Solution algorithm for the bi-level discrete network design problem, Transportation Research Part B: Methodological. 39(2005)479-495