Search results

The epitaxial growth performed by NRL used an Aixtron/Epigress VP508 hot wall chemical vapor deposition reactor and standard silane/propane chemistry[2].
The MOSFETs presented in this paper have the best-reported performance demonstrated with a conventional inversion-mode double-implanted MOSFET structure in the 3-4kV voltage range [5, 6].

Fabrication of Ba-Ti-B-Si-O Glass-ceramics for LTCC Cui Xuemin1, 2, Zhou Ji2, Li Bo 2, Shen Jianhong2 and Wang Yuehui2 1 School of Chemistry and Chemical Engineering, Guangxi University, Nanning 530004, China 2 State Key Laboratory of New Ceramics and Fine Processing, Tsinghua University, Beijing 100084, China Key words: LTCC; Glass-ceramics; Dielectric constant; Dielectric loss Abstract.
Introduction Low temperature co-fired ceramic (LTCC) technology is a low cost process for fabricating multi- layers ceramic structure, which is applied for packaging substrate, RF filters, resonators and antennas etc. [1,3-10].

Syntheses and properties of 1-（2-ethyl-1-benzofuran-3-yl）-2-（2-methyl-1-benzothiophene-3-yl）Perfluorocyclopentene Zhaoyan Tian, Fengxia Sun and Shouzhi Pu* Jiangxi Key Laboratory of Organic Chemistry, Jiangxi Science and Technology Normal University, Nanchang 330013, P.R.China pushouzhi@tsinghua.org.cn Keywords: Diarylethene; Photochromism; Synthesis; Kinetics Abstract.
The structure of compound diarylethene 1a was characterized by 1H NMR spectroscopy. 1H NMR (400 MHz, CDCl3), δ (ppm) 0.647 (t, 3H, -CH3), 2.267 (s, 3H, -CH3), 2.40–2.44 (m, 2H), 7.2–7.34 (m, 4H), 7.47 (d, 1H), 7.58 (d, 2H), 7.67 (d, 1H).

Allelopathic effect of Sargassum fusiforme on growth of Karenia mikimotoi Chunying Yuana, Yang Zhaob, Shuo Yangc, Qingman Cuid Tianjin Key Laboratory for Marine Chemistry and Resource, College of Marine Science & Engineering, Tianjin University of Science and Technology, Tianjin 300457 aemail: cqm80@163.com, bemail:zhaoyang@tust.edu.cn, cemail:yangshuo@tust.edu.cn, demail:cqm80@tust.edu.cn Keywords: Sargassum fusiforme, Karenia mikimotoi, allelopathic effect Abstract.
In addition，macroalgae can change the structure and alternating sequence of aquatic ecosystem by reinforcing each other, have the obvious effect of ecological restoration[2].

The composite ceramic coating, dual-scale structure or hard particle in Al-Sn alloys are also good ways to obtain high resistance to wear [5,6].
Fetzer: Materials Chemistry and Physics Vol. 131 (2011), p. 241 [8] H.

College of Chemistry and Chemical Engineering, Central South University, Changsha 410083, P.
Structure and catalytic activity characterization of Fe2O3/CNT.

When the atomic ratios of B and F to Ti are 0.2 and 0.05, respectively, and the calcination temperature is 600℃, the synergetic effect of boron and fluorine effectively tunes the energy band structure, improves the surface area and enhances the light photo catalytic activity of TiO2.
A: Chemistry Vol. 143 (2001) p221

Obviously, GO and Te-GO are both have folding structure, but the sheets of graphene in Fig.3c are easier to pile than that in Fig.2b which shows that NaHTe is better than hydroxylamine to reduce GO.
Bielawskinduoff, The chemistry of graphene oxide, Chem.

A Primary Study on Preparation of Mullite with Solid Waste LIANG Zhi-yu1, YAN Gui-yang1*, ZHENG Liu-ping1, ZHENG Xing-hua2, RUAN Yu-zhong2 1College of Chemistry and Materials Science, Fujian Normal University, Fuzhou, Fujian, 350007; China 2College of Materials Science and Engineering, Fuzhou University, Fuzhou, Fujian, 350002, China *Corresponding Author: Prof.
The chemical composition, structure and thermal stability of the spent FCC equilibrium catalyst from oil refinery are characterized by XRD, FT-IR, DTA-TG, Fully chemical analysis technique, SEM.
The average structure of mullite can be derived from the closely related but structurally more simple sillimanite (composition:Al2SiO5, x=0.00).
In sillimanite, like in other mullite type structures, edge-connected AlO6 octahedral chains run parallel to the crystallographic c-axis [5-8] .
In addition, the inner structure of equilibrium FCC catalyst samples and the growth of mullite crystals are described.

Results indicate that the ceramic coating on pure titanium by micro-arc oxidation is a porous mixed crystal structure which is mainly composed of such elements as Ti, O, Ca and P.
Under the common action of thermochemistry, plasma chemistry and electrochemistry, through periods of common anode oxidation, spark discharge, micro arc oxidation and arc quenching, arc discharge is produced on the surface of base valve metal, which oxidizes ceramic coating in situ growth and the coating mainly contains base metal oxides.
JEOL JSM-7001F SEM was used to observe micro structure on the surface of MAO film, and EDS was used to analyze its elemental composition.
Because the MAO film is a porous structure, so substrate can be tested by X ray diffraction, therefore, Ti substrate exists.
The film is a mixed crystal structure which contains anatase TiO2 and rutile TiO2, and the main crystal phase is rutile TiO2, which content is 68.01%.