Search results

These data greatly facilitate the determination of the required humidity and pressure parameters for the production of defect-free products. 2.
Due to the wide prevalence of this type of raw materials, we can talk about a significant reduction in the cost of finished products.

Growth at higher Rg (~5µm/hr) with HCl addition caused an additional order of magnitude reduction of the BPD concentration (4.4x10 3 cm-2) (Fig. 1b), thus indicating that higher Rg as well as possibly different effective Si/C ratio caused by HCl-induced dissociation of the Si gas-phase clusters enhanced BPD conversion during the growth.
ThD arrays (substrate-related) Dislocation-free at mesa-walls downstream step-flow BPD generation at mesa-walls upstream step-flow Rare BPD at mesa-walls with a small angle to step-flow 10 µm [ ]0211 Summary The previous photoluminescence and optical microscopy data indicating good quality of the halocarbon epitaxial growth at temperatures as low as 13000C [1] were supported by analysis of the dislocation concentration.

From the data obtained, it was found that the acid value of SHL noticeably decreased after heating.
However, the reduction of acid value was not explicitly observed in SHL-PHT that reacted for 6 h and 24 h (SHL-PHT6h and SHL-PHT24h).

The values of µr * (µr * = µr'−jµr", j = 1− ) and εr * (εr * = εr'−jεr") were calculated from the data of both S11* and S21* .
This result suggests that the reduction in weight of absorber is also possible.

The small ratio difference between the design and experimental data is linked with the technology process’s uniformity (dimensions, channel length and ohmic contacts).
This slight change is due to the reduction of the channel resistance and increases of the drift resistance contribution to the VDMOS conduction mode.

Recently, package density of electronic devices is increasing for performance improvement and cost reduction.
Through data fitting, Cp and Cf for the above two systems are obtained and shown in Table 1.

However, during superplastic deformation, the metal will not neck because any local reduction in section leads to an increase in strain rate which in turn increases the flow stress[1].
The maximum gas pressure is 5MPa and the pressure profile can be uploaded from preset data files.

Compared to steel and concrete, bamboo has fairly good mechanical properties, thermal insulation performance, good effect of energy conservation and emissions reduction[2].
Shear experiment results show that when the shear span ratio less than or equal to 2, composite shear damage occur, when the shear span ratio is equal to 3, damage characteristics and damage of the bending are similar, and put forward a kind of composite beam shear bearing capacity calculation method, calculated value agreed well with experimental data

As well as their uses as permanent magnets, common applications are as magnetic recording and data storage materials, and as components in electrical devices, particularly those operating at microwave/GHz frequencies [1].
The decrease of Ms after substituting more La content from x=0.20-0.40 may be due to magnetic dilution with a change of the Fe3+ (3d5 high spin) valence state to Fe2+ (3d6 low spin) state on a site by substitution of the Ba2+ sites with La3+ ions and the existence of spin canting promoting reduction of superexchange fields [4].

Overview of FPGA Broadband Power Amplifier Digital Pre-distortion Theory In the broadband power amplifier module, FPGA is mainly used to complete the real-time processing of base band input signal, and realize the parallel data processing, including ADC and DAC control communication, DSP control communication and signal modulation real-time compensation and so on [3, 4].
It needs to set a threshold value, when the signal exceeds the threshold value; it needs to enter a reduction peak at this position, as shown in Figure 5.