Search results

Studied the literature 1,2 and then cold rolling reduction rate on the crystallization temperature; literature 3,4 studied the annealing process on cold-rolled plates and mechanical properties； The experiment was simulated in laboratory conditions bell-type annealing process to study the annealing temperature on the mechanical properties of steel plate SPCC rule.
Specimens of each heat treatment process to prepare 3, to ensure data accuracy.

Reduction of interface defects in the case of higher annealing temperature was observed, and it is necessary to evaluate the mobility to demonstrate its passivation effect.
Data on the right side correspond to the reported value in [2].

However, the effect of OTS film on SiC film reduction of friction force is small for the different roughness patterns.
Small roughness Small roughess Large roughness Large roughness Fig.4 The roughness values of SiC film and OTS film on the different topography for (a) straight roughness surface (b) cross roughness surface Fig.5 Contact angle for the OTS surface material In the contact angle analysis of various surfaces, the measurement data of each test piece was obtained from the mean of five measurements.

Tab. 1 Two kinds of sludge dewatering way run data Plant Sludge Dewatering System water content in remaining sludge Treatment Cost yuan/t(sludge) Water Content in Untreated Sludge Electricity Flocculant Maintenance Costs Amortised Installation Cost Total Old Plant Belt Pressure Filter 98% 2.70 3.2 2.88 0.50 9.28 80% New Plant Plate-frame Pressure Filte 98% 1.76 _ 0.32 0.78 2.86 50% Proposals and Conclusions It is suggested to mix the lime milk with lime powder to adjust the pH value in the sewage disposal system.
Each production enterprise is supported to increase investment in environmental protection and improve the processing section in order to reach the goal of energy saving and emission reduction, so the primary materialization and oxidation treatment is a better way.

On the other hand, at high pH, the oxidatio efficiency rapidly decreased, not only by decomposition of hydrogen peroxide, but also by deactivation of a ferrous catalyst with the formation of ferric hydroxide complexes leading to a reduction of radical[15-17].
Reactive Black 5 by Fenton-like oxidation process[8].According to experimental data, Fig.6 shows a comparison of three kinetic models for the experimental results.

Compared to the untreated specimen shown in Figure 1, the microstructure in Figure 3 shows some changes in grain size reduction due to shot peening process.
Based on the data presented on Figure 5, the hardness of the treated plate is significantly increased.

Response surface is created based on the location of groove (x1, x3) and the diameter (x2) by using the data obtained through CCD, as shown in Table 1.
Compare to genetic algorithm, SQP algorithm shows similar amount of reduction in maximum contact pressure but since the amount of time spent for the optimal process is 441 times less, SQP algorithm would be more advantageous for the design of optimum stress relief groove on hub face of press-fitted assembly.

When the stress in the sample reaches the maximal value σ*, the sample quickly starts to loss of load capacity due to the formation of micro and macro defects, which leads to the significant reduction of stresses and the further increase of the deformation.
The observed effect can be predicted using the incubation time criterion, and obtained theoretical curves are in good agreement with the experimental data.

The data was presented as mean ± SD.
We observed the reduction of cells invading and migrating through the reconstitute base membrane in a dose-dependent manner.

Schematic diagram of (a) a zigzag and (b) an armchair nanotube The model of graphene sheets was simulated and the gathered data was transferred to a commercial finite element (FE) package, where C–C bonds were modeled as circular beam elements [17].
It was concluded that existence and development of any defection and impurities in the structure of nano-sheets result in a significant reduction in the vibrational response and stability of these specific nano-materials.