Search results

When Sodium Silicate is added to concrete buildings, the content of calcium hydroxide drops while the content of calcium silicate hydrate (C-S-H gel) increases as compared to untreated concrete structures.
Because the expansive and insoluble C-S-H gels partially fill the micro-pores, micro-voids, and micro fractures in the concrete structures, the sodium silicate-based concrete sealers are basically surface hydrophilic agents.
Several detached self-mending techniques can increase the service life of large structures at a low cost and with few difficulties.
It will be completely consistent in nonpartisan and fundamental structures.
[5] Kurdowski W (2010), “Chemistry of cement and concrete”, Scientific Publishing PWN. – Warszawа, 2010. – 728 р (https://doi.org/10.1007/978-94-007-7945-7) [6] M.

Both are single-phase ductile materials but the crystallographic structure of copper is face-centered cubic while it is body centered cubic for Armco iron.
Both are single-phase ductile materials but the crystallographic structure of copper is face-centered cubic while it is body centered cubic for Armco iron.
The difference in slip markings morphology probably results from the dislocation motion mechanisms which depend on the crystallographic structure (face-centered cubic for copper and body centered cubic for Armco iron).
Mayer, Very high cycle fatigue of thin walled tubes made from austenitic stainless steel, Fatigue of Engineering materials and structures, 25 (2002) 837-844
Reed, Elastic properrties of metals and alloys: iron, nickel, iron-nickel alloys, Journal of Physics and Chemistry, 2 (1973) 531-617

The layered MnOx loosened gradually and formed flaky structures, and spalling finally occurred with further reusing.
However, the changes of WZ02 surface morphology was slight after recycling and the surface wrinkles and micropore structure did not change at all.
Compared with WZ01, the structure of WZ02 prepared by hydrothermal method with CTAB as templates changed obviously.
The removal efficiencies of OA, the stability after recycling and the structure of WZ02 were all superior to those of WZ01.
[8] Zhang LH, Gao WW, Chen ZC, CoAl2O4/Ceramic Honeycomb Catalyst: Preparation and Performance on Catalytic Ozonation in Wastewater Treatment, Chinese Journal of Inorganic Chemistry. 33 (2017) 985-992

The engineering features in the raw dataset are derived from the structure of the antigen-antibody complex and the propensity score.
There are 17 datasets from the domains of quantum mechanics, physics chemistry, biophysics, and physiology on MoleculeNet.
Input is in the form of 3d structure data from the exposed residues of the antigen chain, each with the "epitope" or "non-epitope" label.
Vlahovi, “PSAIA – Protein Structure and Interaction Analyzer,” BMC Struct.
Li, “Tertiary structure-based prediction of conformational B-cell epitopes through B factors,” Bioinformatics, vol. 30, pp. 264–273, 2014

Note that the structure of the AlFeSi particles can vary [6,7].
Within the grains, the matrix structure is supersaturated with alloying elements.
In the cast structure, the particles may appear to form a continuous network, but after homogenisation the particles are discrete and appear more rounded than those in the as-cast structure.
As-cast Homogenised Figure 6: Optical micrographs of 6005 alloy billet illustrating the as-cast structure and a fully homogenised structure after 32h at 590°C [12].
In other cases, the problem stems from the casting cooling water chemistry.

The crystal structure of Ru is depicted in Fig. 1b.
An 21 × 21 × 21 Monkhorst–Pack k-point mesh was employed to approximate the definite integral over the Brillouin zone of cubic structures (Pt and Pd), and a 9 × 9 × 6 k-point Γ-centered grids mesh was used for hexagonal structure Ru [9].
The unit cell was fully optimized in order to obtain the equilibrium crystal structure.
Fig. 1 (a) Fm-3m: Crystallographic structure of the Pt or Pd; (b) P63/mmc: Crystallographic structure of the Ru.
Physical chemistry chemical physics : PCCP. 10 (2008) 3530-3534

The increase in density shows a change in the structure of the glasses as the oxide content increases [4].
Therefore, the glass structure becomes loosely packed.
Materials Chemistry and Physics, 217, 519-526
Journal of Molecular Structure, 1086, 239-245
Effect of V2O5 on Structure and Electrical Properties of zinc borate glasses.

Preparation and Properties of Silicone Modified Epoxy resin, Nano-TiO2 and Nano-TiO2/Micron-Al2O3 Polymer Alloys Putty Mingqiu Wang 1, a, Jun Yan 2, b, Haiping Cui 3, c and Shiguo Du 4, d 1The 3rd Department of Mechanical Engineering College, Shijiazhuang 050003, China 2 The 3rd Department of Mechanical Engineering College, Shijiazhuang 050003, China 3 Physics and Chemistry Section of Mechanical Engineering College, Shijiazhuang, 050003, China 4 The 3rd Department of Mechanical Engineering College, Shijiazhuang 050003, China amqwang1514@163.com, byan-junjun@263.net, cyan-junjun@263.net dyan-junjun@263.net Keywords: epoxy resin; polymer alloys putty; silicone; wear resistance Abstract.
Because nano-structured particles not only present outstanding dispersing properties of nano-sized particles but also have good qualities of micron-powders.

On a more pragmatic point, these modules, available as adownload from Rensselaer's web site, also provide a convenient, structured basis for taking notes at the lectures and recitations and for home study and distance education.
Modules enhance students preparation for careers in industries based on metals and alloys, semiconductors, glasses and ceramics, geosciences, chemistry, and aeronautics. 3.

or AlNi Al-rich since additional structure analyses have to be done in order to conclude its identification, i.e.
Liu: Materials Chemistry and Physics 42 (1995), p. 77 [2] B.