Search results

But it is well known that the reduction potential of Al is too negative to permit its electrodpositon from aqueous solution, H2 evolution being the preferred process.
It is found that the deposited layers only show the presence of the Al and Fe phase.
The relative intensity of the Al phase increasing in fig. 4b should be caused by the increasing of the thickness of the aluminum layer.
Zein El Abedin, F.
Vol. 29 (2005), p. 1 10 20 30 40 50 60 70 80 90 Fe Al Intensity, a.u. 2 θ , degree a) 10 20 30 40 50 60 70 80 90 Fe Al Intensity, a.u. 2 θ , degree b)

No Record PGA Interval Eh 1940, El Centro Site, 270 Deg 0.3569g 53.72s Et 1940, El Centro Site, 180 Deg 0.2142g 53.46s Ev 1940, El Centro Site, Vertical 0.2468g 53.78s Th 1952, Taft Lincoln School, 69 Deg -0.1557g 54.38s Tt 1952, Taft Lincoln School, 339 Deg -0.1793g 54.40s Tv 1952, Taft Lincoln School, Vertical 0.1048g 54.26s Sh 1971, San Fernando, 69 Deg 0.3154 g 61.84s St 1971, San Fernando, 159 Deg 0.2706 g 61.88s Sv 1971, San Fernando, Down -0.1563 g 61.86s Time History Analyses and Results Three time history records (each record consisting of two horizontal and one vertical component) were used to conduct time history analyses on the bridge.
[15]Mander J B,Dhakal R P, Mashiko N,et al. (2007) Engineering Structures,29(10): 2662-2672.

(English Ed. 26, 673–680 (2017). https://doi.org/10.1007/s13726-017-0552-y [19] Abd El-baky, M.A.: Evaluation of mechanical properties of jute/glass/carbon fibres reinforced hybrid composites.
Fibres Polym. 18, 2417–2432 (2017). https://doi.org/10.1007/s12221-017-7682-x [20] Megahed, M., Abd El-baky, M.A., Alsaeedy, A.M., Alshorbagy, A.E.: An experimental investigation on the effect of incorporation of different nanofillers on the mechanical characterization of fibre metal laminate.
Part B Eng. 176, 107277 (2019). https://doi.org/10.1016/j.compositesb.2019.107277 [21] Selmy, A.I., Abd El-baky, M.A., Hegazy, D.A.: Mechanical properties of inter-ply hybrid composites reinforced with glass and polyamide fibres.
Compos. 35, 1401–1410 (2016). https://doi.org/10.1177/0731684416652488 [25] Krishnasamy, P., Rajamurugan, G., Thirumurugan, M.: Performance of fibre metal laminate composites embedded with AL and CU wire mesh.

Rasmussen et al [48, 49] applied isoparametric spline finite strip analysis of perforated thin-walled steel structures.
[39] Airumian, E.L.
[42] Jansen, E.L., Rahman, T., Rolfes, R.
[43] Rahman, T., Jansen, E.L., Gürdal, Z.

Sousanpour, Al.
Sharaf El-Deen, M.
El-Dessouky, M.
El-Dessouky, “Characterization and Leach Investigation of Sodium Silicate Matrices Used for Immobilization of Radioactive Waste,” in M.

Graphene Oxide as a Substrate for Biosensors: Synthesis and Characterization Mohamed Adel1,2,3,a, Abdel Hady A Abdel Wahab4, b, Ahmed Abdel-Mawgood1,c and Ahmed Osman Egiza1,d 1Biotechnology Program, Institute of Basic and Applied Science, Egypt-Japan University of Science and Technology, New Borg El-Arab, Alexandria 21934, Egypt. 2Botany and Microbiology Department, Faculty of Science, Helwan University, Cairo 11790, Egypt. 3Graphene Center of Excellence for Energy and Electronic Applications, Egypt-Japan University of Science and Technology, New Borg El-Arab, Alexandria 21934, Egypt. 4Department of Cancer Biology, National Cancer Institute, Cairo University, Cairo 11796, Egypt.
[16] Hessein, A., Wang, F., Masai, H., Matsuda, K., & Abd El-Moneim A.
[17] Eigler S et al.

Dhale et al. [13] discovered a novel method for cooling using car radiators to limit fuel consumption.
El Maakoul, A.
El Metoui, A.
El-Leathy, Z.
Al-Sofyany, The effect of nanofluid concentration on the cooling system of vehicles radiator, Adv.

Introduction β-sialons, which have high heat resistance, chemical stability and wear resistance are formed by simultaneous substitution of Al and O elements with Si and N in β-Si3N4 materials. 1 Though the expensive reaction sintering involving many processes is one of the common method to synthesize β-sialons, in recent years a cost effective MA-CS has emerged as a promising method in their powder syntheses.
Experimental Procedure An appropriate proportion of β-sialon (z=3) starting materials such as Si, Al and α-Al2O3 were taken and was planetary milled for 18 mins. followed by combustion synthesis under a low nitrogen pressure of 1 MPa.2 The sialon powders thus obtained were again pulverized by planetary milling to 1h to break the CS caused agglomerations and to increase the sintering ability of powders.
Watari et al. 6 reported that the thermal conductivity is dependent on the internal defects and dislocations present in the grains.
Further, it was seen that the thermal conductivity decreases with the increase of alumina content in β-sialon ceramics. 7 Thus, in our study of β-sialons, a hypothesis is suggested that the replacement of Al and O ions with Si and N ions will turn to substitutional impurities in the grains and lead to scattering of phonons.
Sergei and E.L.

Mangeron, No. 59A, 700050, Iasi, Romania 2University “Al.I.Cuza” of Iasi-Romania, Faculty of Physics, Blvd.
Et al. (2008).
Et al. (2008).
El Naschie’s epsilon (infinity) space-time and scale relativity theory in the topological dimension D=4.
Chaos Solitons & Fractals, 32 (3), 1231-1240 [23] Gottlieb, I.; Agop, M.; Jarcau, M. (2004), El Naschie’s Cantonian space-time and general relativity by means of Barbilian’s group.

Wang et.al.
prepared the TiC films by filtered cathodic vacuum arc technique using the C2H2 gas as the precursor [8], El Mel et. al. by a hybrid plasma process combining Physical Vapor Deposition and Plasma Enhanced Chemical Vapor Deposition [9], and Sedlackova et al. by DC magnetron sputtering [10].
Martínez-Martínez et al. prepared the TiC nanocomposites by double magnetron sputtering.
This result is in the correlation with work of Zhang et. al [19], they were observed no dominant texturing in TiC.
El Mel, B.