Search results

In the cooling process, the temperature variation curves at the distance of 5mm and 10mm were recorded by data acquisition system.
[17] G.P Dolan, J.S Robinson, Residual stress reduction in 7175-T73, 6061-T6 and 2017A-T4 aluminum alloys using quench factor analysis, Journal of Materials Processing Technology. 153 (2004) 346-351

The compressive strength of the concrete was tested at three different percentages of PPF, and it was noted that the strength of concrete showed an increasing trend up to 1% content of PPFs, after which reduction in the compressive strength started.
Author Contributions CFA: Data Collection, write-up and research, MM: Casting of Concrete with 0.5% and 1% PPFs, MAQ: Concrete casting for 1.5% PPFs, WBM: Material Collection and arrangements at the casting site, MAC: Write up and tables preparation, HAF: Preparation of Figures and finding references Acknowledgment The authors would like to thank every person/department, who helped throughout the research work, particularly Dr.

The sharp reduction of the army and weapons, the policy of Russia's import substitution in this area, almost led to stopping the large number of machine-building enterprises and to almost two times lowering the production in Ukraine.
Analysis of the data of the Ministry of Finance to balance the budget showed that in 2000 and 2002 there was a budget surplus of $ 1.0 billion UAH and 1.6 billion UAH, respectively.

The ROOT package tool has been used for conversion of MCA measuring spectrum data and peak analysis.
This may due to the reduction of incoming photon number that reach collimation hole of the detector.

All experiments were done in triplicate and quantitative data expressed as means ± standard deviation.
This is consistent with previously reported reduction in cell density with differentiation of MSCs in alginate gels with incubation time [14].

Agglomeration may bring difficulty to spin and lead to reduction in strength of fiber.
And the data is shown in Table 3.

Using this data the field of blast wave loading parameters characteristic for mine-blast loading of LAVs is defined and presented with green colour on Fig. 2.
Various ways of “leakage” reduction can be applied in order to increase the transfer of energy but in some cases none of them are completely effective.

First, the reduction of the samples’ fracture toughness can be caused by the grain growth at higher T2 such as 1400℃ and above.
Conclusion Based on the data obtained, it is possible for ZTA to achieve full densification via two-stage sintering with shorter holding time with careful selection of sintering parameters such as T1 and T2.

Fig.1 reveals that the diffraction peaks located at 2θ = 32.4, 34.5, 36.8, 48.1, 57.8, 63.5, 68.3 and 69.2 correspond to (100), (002), (101), (102), (110), (103), (200) and (112) diffraction planes of GaN hexagonal phase, respectively, with lattice constants of a = 3.189 Å and c = 5.200 Å, in good agreement with previously reported data on GaN [2, 20, 22].
Thus, the latter species are likely to control the reduction and nitridation reaction, respectively [29-30].

introduction Technical need walk earlier than Saving, and Emissions reduction need to change the system of innovation or energy consumption[1].The strategy has achieved significant results with the revitalization of the northeast old industrial.
This requires further scientific survey research data through scientific analysis, adjusting the rational distribution of power supply facilities.