Search results

Fig. 4 Fitting of the theoretical (solid lines) and measured (open circles) data for hot forged Ti-1023 using CMWP Engineering stress-strain curves of the tensile tests are shown in Fig. 5.
The reason of dislocation density reduction is that dislocations annihilated during heat treatment.

The explosive welding resulted also in a slight thickening of the aluminium layer in the specimens, with a simultaneous reduction of the aluminium tube length.
By comparing the data in Fig. 8 with the shape of the AZ31 alloy specimens after the compression test (Figs. 3 and 4), it can be presumed that the rapid decrease in the force value coincides with the moment of breaking of the deformed specimens.

In Ni base superalloys the initial dislocation density is generally low, so when small loads are applied, the reduction square term in Eq. 4 is small and can be neglected.
Only the data up to 15% are reported, since they are the most significant.

The PSA results of the particle size distribution are shown in FIG.7, and all the data have been normalized to the same amount of 20-50 micron-size particles.
There were inconspicuous oxidization/reduction peaks on CV curves, which proved that materials were relative chemical stable in an acid solution.

However, no data is given for the initial powder mass, enabling no insight into recycling efficiency.
Especially sieve residue and wet separator losses show a high potential for waste reduction and efficiency increase.

This alternative has not been studied in depth, since the data resulting from the constant cross-section tower indicate that the axial force (free prestress) shall decrease the own frequency by 0.2 to 0.3 Hz.
IABSE Conference New Delhi, India, (2005): Role of Structural Engineers towards Reduction of Poverty.

Since the limitation of published data availability of the study area, therefore we conducted bathimetric measurements by ourself.
It is an essential element for plant life, but when there is too much phosphate in water, it can speed up eutrophication (a reduction in dissolved oxygen in water bodies caused by an increase of mineral and organic nutrients) of rivers.

The reduction of CaO might be due to the leaching of free lime during impregnation.
A good dispersion of La2O3 on the CFA support was observed by XRD data.

It is probably caused by local reduction of fibres amount.
Fig. 5 Basic schema of hall Fig. 6 Scheme of bores placement Table 3 Data from sample testing Number of specimen Diametr [mm] Thickness of bore [mm] High of tested sample [mm] Cube strength [MPa] Amount of fibres (kg/m3) 1 A 94.3 190 117.4 42.8 18.3 2A 94.3 192 Inappropriate sample 3 A 94.3 182 166.5 40.1 12.2 4 A 94.3 160 133.5 38.3 18.5 Tests of subsoil were also performed and these tests has shown that subsoil do not exhibit volume changes which could be cause failures of floor.

The test bench is connected to a desktop computer to ease the data export, treatment, and visualisation.
At the same time, the reduction in costs of many of the available materials is making it possible to make the 3D printing technologies applicable to fields that previously were out of the spot [2].
For example, one step beyond in the measuring equipment is the implementation of systems based on computerized strain gauges, from which the data acquisition is incorporated using Arduino microcontroller boards [21, 22].
The funders had no role in the design of the study; in the collection, analyses, or interpretation of data; in the writing of the manuscript, or in the decision to publish the results.
Available online on 22/02/2023: https://www.impresoras3d.com/wp-content/uploads/2021/05/TDS-FILAFLEX-82A-ORIGINAL-_-TECHNICAL-DATA-SHEET.pdf