Search results

Data Analyzer from Engine - AVL PIEZO CHARGE AMPLIFIER 4.
At 30% blend and 40% blend there is a remarkable reduction in CO.

They found that Ni contents higher than 0.5 wt % yield a significant reduction in both Rp0.2 and Rm the T6 heat-treated alloys.
Kaufman, Properties of aluminium alloys – Tensile, creep and fatigue data at high and low temperatures.

The results of these data lead to two conclusions.
These results go against the theoretical prediction in Eq. (1) which assumes an area of zero imposed strain at r = 0 but the results can be explained by strain gradient plasticity modelling [19] or by the increase in the value of effective strain at the disc centre attributable to the continuous thickness reduction while torsion is at high pressure [20].

The data of the SBS were tested for normality with the Kolmogorov-Smirnov method.
Recently, the manufacturers have developed high-intensity LED units (e.g., VALO, FlashMax P3) and claim that they provide a significant reduction in the exposure time needed to bond orthodontic attachments.

All these data are necessary for assessment of durability of primary lining as well as for defining of necessary capacity of secondary lining [1].
Development of cracks is related to shrinkage of concrete, reduction of content of cement and mixing water can help as well as appropriate layout of reinforcement.

Moreover, there is no general line for the effect of the grain size reduction on the jerky flow.
The recorded data were then processed to calculate values of the local strain and strain rate.

For both sets of data a power-law life model was assumed for single crystal superalloy based on the Basquin equation [13], which can be written as: (1) where σa is the stress amplitude, Nf is the number of cycles to failure.
There was little reduction in area or elongation of the specimens during the fatigue process and no evidence of creep damage as a primary contributor to failure was observed for the testing conditions examined.

This process also has the capability to reduce capital and operating costs because of the reduction in the number of equipment units of the plant that has occurred [9, 18-20].
Also, a reflux ratio of 3 and a reboiler duty 78 kJ/min were among the data used for the simulation, which was carried out with UNIQUAC model.

For example, phenolics were disintegrated at high temperatures and longer heating time caused a reduction in the antioxidant activity of phenolic compounds.
These data suggested that alginate could improve the thermal stability of E and maintain its chemical instability during the microencapsulation process [12].

The resistance coefficient change curve was charted according to the data and shown in Fig. 5.
The resistance coefficient of the sand pack tube with PSPEMs aqueous solution rose smoothly, fluctuated when PSPEMs were injected, had only a minor reduction in the subsequent water injection stage, and maintained a high resistance coefficient finally.