Search results

Additionally, the cessation or reduction of signaling is also of great importance for the olfactory perception.
Numerous studies about invertebrate olfactory signaling reported conflicting data.

Kammer [4] showed that sensor placement is related to Fisher Information matrix from the viewpoint of a structural dynamicist who must use the mode shapes extracted from the test data to update prelaunch models.
Park: Order Reduction Based on Singular Values of Modal Matrix Mechanical Systems and Signal Processing, Vol. 8, No. 1 (1994), p. 63~79

This method uses the reflectance data in the visible region to obtain the three relevant parameters, L*a*b*, measuring the brightness, red/green and yellow/blue hue intensities, respectively [14].
In standard formulations, the pigments brightness tends to decrease by improving the calcination temperature (from 1250 to 1550°C), due to the reduction of the chromophor oxidation state.

The coefficient of friction of the sliding couple was recorded continuously during the test by a computer data-requisition system.
The significant reduction in corrosion current density implies that the N-doped TiO2 coatings can help to decrease the corrosion rate of the S.

In the mean time, Ti is active at this high temperature and its oxidation can not be avoided, which leads to high fabricating cost, reduction of its tensile plasticity and fatigue strength.
The first author would also like to thank the data and figures of TC21 alloy after superplastic deformation supplied by Prof.

Table 3 Statistics of the High Performance Concrete Working Performance in Ultra-High-Buildings Number Building Concrete Number Slumping degree Extended degree Slumping time 1 Burj Khalifa Tower C80 / Paving degree: 50cm / 2 Shanghai Global Financial Hub C40 220~240mm Over 500mm Over 2h 3 Sears Tower[5] C25 203mm / / 4 Shanghai Jinmao Mansion C40 230~250mm Over 550mm Over 2h 5 Hongkong International Financial Centrer C60 180~200mm / / Analyzing the above-mentioned data can conclude that general requirement of the slumping degree of the high pumping concrete should be over 200m and the extended degree should be over 500m. 3 Research and development of ultra-high-performance concrete and ultra-high-performance self-compacting concrete and its high performance pumping technology [8] 3.1 Project Introduction West Tower Project in Guangzhou is one of the six landmarks in Pearl River New Town, located in the southwest part of the core financial business area in Pearl River New Town
The admixture should use KJ-JS superplasticizer, whose concentration is 22% and the water reduction rate is greater than 30%.

The specific loading pattern can be seen in the standard JTG D60-2004[12]: loading grade was highway I, 3 lanes along transverse direction, uniform load was 10.5kN/m, concentrated load was 360kN, transverse reduction coefficient was 0.78.
Because Huangpu bridge was a new bridge, the relative data was deficient.

The quantitative metallographic data for volume fraction and mean linear intercept grain sizes of microalloyed steels was summarized in Table 2.
According to these results, Speeding up cooling after finish rolling could increase the yield strength （YS）, ultimate tensile strength (UTS), at the expense of some reduction in elongation and contraction of area.

The nucleation frequency of the phase transformation can be described as follows, )exp() exp() ( hom Pr0 TR Q C Tk G NNNN g m B Active imary −⋅⋅ ⋅ Δ −⋅−⋅= ∗ • θ (2) where, Nprimary is the number density of the Al6(Mn,Fe) constituent particles; NActive is the number density of the Al6(Mn,Fe) particles, on which α-Al(Mn,Fe)Si precipitate has nucleated; and QθC m are nucleation law parameters; =7.3E-2 and Q θC m =125000J/mol; N0 is a tuning parameter; is the critical nucleation energy for homogeneous nucleation of dispersoids and given by ∗ Δ homG 2 3 hom )/(3 16 mm VG G Δ =Δ ∗ πγ (3) where, γ is the surface energy of the precipitate-matrix interface, mGΔ is the energy reduction for the precipitation of one mole precipitate, and Vm is the mole volume of precipitate.
More details of the experimental procedure and experimental data can be found elsewhere [4,5,10,11].

When sintering in air, the donor-doped BTO ceramics exhibit much higher resistivities and PTCR effect than that of sintering in a reducing atmosphere, however, the low room temperature resistivity of the semiconducting ceramics has been obtained by a reduction-reoxidation method [8, 9].
A mark of this data is the shifting of peaks to higher 2q to become more significant when the m (≥1) increased.