Search results

Pyrolysis seems to be a promising substitute for mechanical recycling in the recovery of materials and energy from PW.
Presently, Igbinedion University, Okada is attempting to solve the problem by conducting research and incorporating it into her course offerings. 2.2 Materials and Equipment The materials and equipment used in this study are tabulated as shown in Table 1.
List of materials and equipment used in this study.
Samin, Effects of plastic waste materials on geotechnical properties of clayey soil.
Nigerian Journal of Engineering Science Research (NIJESR), (2021) 40-49

Materials Science Forum Vols. *** (2004) pp.390-395 online at http://scientific.net  2004 Trans Tech Publications, Switzerland Evaluation on Died-pressed Binders of Ti(C,N)-based Cermet Powders C.
Materials Science Forum Vols. *** 391 Fig.1 SEM micrograph of mixed powders The compaction experiment was conducted using a hardened steel die with a 40.0mm×6.0mm cavity and pressing pressure of 150 to 380 MPa was applied with uniaxial pressing at a universal testing machine. 7 grams the mixed powders were poured into the die cavity, subsequently vibrated, and then compacted at designed pressure.
Materials Science Forum Vols. *** 393 Binders BSR and PVA were beneficial to green strength and density under high pressing pressure.
Materials Science Forum Vols. *** 395 References [1] P.
White: Journal of Light Metals.

College of Life Science, Hebei University, Baoding, P.R.
South China Institute of Environmental Sciences, MEP, Guangzhou, P.R .China 3.Guangzhou Institute of Geochemistry,CAS , Guangzhou, P.R .China 4.
Research Center for Eco-Environmental Sciences,CAS,Beijing, P.R.
Materials and Methods 2.1.
The Israeli Journal of Aquaculture – Bamidgeh, 61(4):322-329

Materials and Methods Navel orange samples.
Acknowledgement This work was supported in part by the National Natural Science Foundation of China (No. 30760101) ，Jiangxi Provincial Department of Science and Technology (No. 2009BNB05705) and Jiangxi Provincial Department of Education (No.GGJ08513).
Food Science Vol. 70 (2005), p. 471-476
Park: International Journal of Poultry Science Vol. 5 (2006), p. 964-969.

Preparation and character measurements of ZrO2 films for RF Magnetron Sputtering Tailong Gui1,a, Jiying Wen1,b and Jinshuo Mei1,c 1College of Applied Sciences, Harbin University of Science and Technology, Harbin 15008,China a guitl1952@yahoo.com.cn, b wjy3226268@163.com, c meijinshuo@yahoo.com.cn Keywords: RF magnetron sputtering, zirconium oxide film, transmission rate Abstract.
Before deposition,the glass substrate is cleaned 5min by KQ-50 ultrasonic cleaner,respectively, using acetone,ethanol,and deionized water,and then dry on the DZF-6020 vacuum.ZrO2 thin films were deposited by OLED multi-center multi-coated manufactured by Shenyang scientific instruments developed center of the Chinese academy.Sputtering target material is zirconium dioxide target material (a diameter of 100mm, thickness of 4mm and the purity was 99.9%).
Acknowledgement It is a project supported by natural science funds of Heilongjiang province (E200809).
Mohan: Journal of Vacuum Science and Technology A Vol. 6 (1992), p. 3451-3455

Molecular dynamics (MD) simulations of nanometric scratching with diamond tip are conducted on single crystal copper crystal plane (010), and MD simulations are carried out to investigate the mechanism of material removal and the generation of defects on the surface, subsurface and inner of material.
Ye [12] performed MD simulations of the nanometric cutting of single-crystal copper with the EAM to analyze the nature of material removal, chip formation, material defects and frictional forces.
The initial atomic configuration of the workpiece material is created from the face-centred cubic (FCC) copper lattice.
Raff: Journal of Machine Tools & Manufacture, Vol.44 (2004), pp.1115-1124
Raff: Materials Science and Engineering A, Vol.340 (2003), pp.58-67

Introduction The interest in using recycled materials derived from construction and demolition waste is all over the world.
Raw Materials The cement used in this study was a locally produced ordinary Portland cement equivalent to ASTM Type I Portland cement.
Chemical composition of raw materials(%).
J, "Recycled concrete as an aggregate for concrete," Materials and Structure, Vol.2, No.65, pp.371-378 (1978) 6.
J., "Introduction to modern Colloid Science," pp.32-56, 274-279 IN Oxford Univ.

Ratio of materials impact on product performance.
Experimental results show that, within a certain range to improve the material added to the amount of acrylamide flocculants can increase the molecular weight of chitosan withacrylamide when the mass ratio to 1:10, the product is insoluble in water.
Acknowledgements This work was financially supported by the Anhui Natural Science Research Foundation (KJ2011Z100).
Nie: Journal of Anhui University of Science and Technology (Natural Science) Vol. 23(2003), p.49 (In Chinese)
[9] F.H.Wang,H.S.Li,X.C.Huang: Agricultural Sciences of China Vol. 36 (2003), p.691

To this end, the activated sludge in the SBR reactor materials, applied regression designed to build mathematical models to study the determination of the conditions of its catalase.
Materials and methods Preparation of enzyme solution.
A Review on the Researches of Enzyme in Activated Sludge System.J Environmental Science, 1990, 11(6): 54-58.
In Chinese [3] YANG Lan-fang,ZENG Qiao,LI Hai-bo,YAN Jing-jing.Measurement of Catalase Activity in Soil by Ultraviolet Spectrophotometry.J Chinese Journal of Soil Science, 2011, 42(1): 207-210.
Hubei Science and Technology Publishing House.1985.

Fabrication and characterization of Superhydrophobic film on Titanium substrate Dong-ping Long 1,2,a*, Jian-rong Xue 3,b, Zhi-xin Yan 1,c (1.Colloge of Electromechinal Engineering,Hunan University of Science and Technology,Xiang Tan 411201 ,China 2.Institute of Powder Metallurgy ,Central South University,Chang Sha,410083,China 3.school of Chemistry and Chemical Engineering,Hunan University of Science and Technology XiangTan 411201, China） aemail: ldp_1030@163.com, bemail:xjr_1111@163.com, cemail:584047199@qq.com *To whom correspondence should be addressed.
It play an important role in many applications,such as contamination prevention, biocompatibility, enhanced lubricity and durability of materials.
Based on this principle there are two way to fabricate superhydrophobic surface: one is constructing a special micro-nano structured morphologies on low surface energy material,the other is using the low surface energy material modification micro-nano roughness surface.
Acknowledgements This work was financially supported by the National Natural Science Foundation of China (51105385, 31271057), and China's postdoctoral science foundation(2012M511397).
References [1]Elena Celia, Thierry Darmanin, Elisabeth Taffin de Givenchy,et al.Recent advances in designing superhydrophobic surfaces,Journal of Colloid and Interface Science[J], 2013,402 : 1–18