Search results

For instance, Scott et al. [4] enhanced the YS of TWIP Fe-(18-22) Mn-0.6C by microalloying elements, such as Nb and Ti.
In this context, Jo et al. [6] studied the dependence of deformation mechanism and tensile properties of TWIP steel Fe–18Mn–0.6C–1.5Si on grain size.
Saha et al. [7] succeeded to fabricate nano-structure of a TWIP steel with 400 nm after applying very high cold rolling reduction of 92% with recrystallization at a low temperature.
Kannan et. al. [11] studied the corrosion behaviour of Fe-0.05C-29Mn-3.1Al-1.4Si in comparison to IF steel.
Yen et al. [15] studied the effect of vanadium carbides on the mechanical properties of TWIP steel Fe–21.6Mn–0.63C–0.87V after SRX at 850 ℃ for 60 s on a vanadium-containing TWIP steel Fe–21.6Mn–0.63C–0.87 V.

For PiN diode fabrication, the anode region with a concentration of 8.0×1019 cm-3 was formed through high temperature Al implantation at 400°C, and then an activation anneal was performed at 1700 °C for 30 min.
Circular Al-based metal contact stacks (Ti/Al/Ti/Au= 70nm/100nm/5nm/120nm) were patterned on the anode region, and Ni-based metal contact stacks (Ti/Ni/Ti/Au=20nm/90nm/5nm/120nm) were deposited on the back side of substrate for cathode electrode.
Electroluminescence (EL) images were additionally obtained under identical stress to a mesa-isolated PiN diode without proton implantation capturing an expansion of dark regions originating from the glide of stacking faults (Fig. 5).
Kimoto et al., "Understanding and reduction of degradation phenomena in SiC power devices," 2017 IEEE International Reliability Physics Symposium (IRPS), Monterey, CA, USA, 2017, pp. 2A-1.1-2A-1.7, doi: 10.1109/IRPS.2017.7936253
Veliadis et al., "Degradation and Full Recovery in High-Voltage Implanted-Gate SiC JFETs Subjected to Bipolar Current Stress," in IEEE Electron Device Letters, vol. 33, no. 7, pp. 952-954, July 2012, doi: 10.1109/LED.2012.2196674

Obtaining Directly Quasi-Square Open Ring FSS Constitutive Effective Parameters by Using Coupled WCIP - Retrieval Method Saida Mellal1,2,a,Toufik Ziar1,3,b*, Hichem Farh1,3,c, Khalid Hati4,d, Badreddine Zemmal3,e, Ilhem Touaibia3,f ,Azizi Cherifa1,g and Henri Baudrand5,h 1Materials & active devices laboratory LCAM, Larbi Ben M’hidi University of Oum El Bouaghi, Algeria. 2Sciences of matter Department, S.T Faculty, Abas Laghrour University of Khenchela,12000, Algeria 3Sciences of matter Department, S.S.N.V Faculty, Larbi Tebessi University of Tébessa, 12000, Algeria 4Departement of physics,Abdelmalek Essaâdi University of Tetouane ,Morroco 5Laboratoire d’Electronique ENSEEIHT de Toulouse, France amellalsaida95@gmail.com, btoufik1_ziar@yahoo.fr, cfarhichem@gmail.com, dhati.khalid@gmail.com, ezemmal2@yahoo.com, famincheria120@gmail.com, gaziziche@yahoo.fr, hhenri.baudrand@yahoo.fr Keywords: FSS, WCIP, retrieval method, effective parameters, scattering parameters, planar
The Theory of the Iterative Method This method has been introduced firstly as the Fast Wave Concept Iterative Process (FWCIP) in (Azizi et al. 1995) [4], applied since one decade to many kinds of radio frequency integrated circuits and diffraction problems in (N’gongo and Baudrand, 1999)[5].
The (mostly) same method is denoted in literature as Transverse Wave Formulation - TWF (Wane et al. 2005) [6] and more recently Wave Concept Iterative Procedure – WCIP (Baudrand et al. 2007)[7].WCIP compares favorably with other commercially available software regarding the precision and promises better performance in computation efficiency in structures with very different layer heights.
Feng et al., "Fabrication of Single-Negative Metamaterials Based on Coplanar Waveguide", Advanced Materials Research, Vols. 160-162, pp. 418-423, 2011
Ghaedizadeh et al., "Geometric Bounds for Buckling-Induced Auxetic Metamaterials Undergoing Large Deformation", Applied Mechanics and Materials, Vol. 846, pp. 547-552, 2016 [4] Azizi M, Aubert H, Baudrand H.

Investigations into dissipative impact have been looked into by Zokri et al. [10]; Mohammed et al. [11]; Prasad et al. [12]; Chowdhury et al. [13]; Akinbobola and Okoya [14].
The following authors, Molla et al. [15]; Zainuddin et al.[16]; Zainuddin et al.[17]; Makanda et al. [18]; Adeniyan et al. [19]; Prasad et al. [20]; Roy and Gorla [21]; Prakash et al. [22]; examined the impact of radiation while studies on non-linear Boussinesq approximation have been investigated under various conditions and geometries different from a cylinder by Mahanthesh et al.[23]; Rakesh and Shilpa [24]; Goren [25]; Thriveni and Mahanthesh [26]; Vajravelu and Sastri [27]; Okoya et al.[28]; Sinha [29]; Mahanthesh et al. [30].
The impact of internal heat generation has been documented by the following authors: Azim and Chowdhury [31]; Azim [32]; Kunnegowda et al. [33]; Kasim et al. [34]; Molla et al. [35]; Opadiran [36]; Mythili et al. [37]; Mythili and Sivaraj [38].
El-Hakiem, S.M.
El-Kabeir, Heat and mass transfer in magnetohydrodynamic flow of micropolar fluid on a circular cylinder with uniform heat and mass flux.

In a work by Sun et al.
With the use of this handheld fully-integrated equipment, Machado et el was able to distinguish lung cancer patients with healthy control with a specificity of 91.9% and sensitivity of 71.4% [67].
Amann, Huda Al-Kateb, C.
[62] Saidi, Tarik, Mohammed Moufid, Kelvin de Jesus Beleño-Saenz, Tesfalem Geremariam Welearegay, Nezha El Bari, Aylen Lisset Jaimes-Mogollon, Radu Ionescu et al.
La Delfa et al.

Leone And et al. 2015 [28] (SR) (KW) (Pu) (V) (P) (SOD) N2 CO2 6 Al alloy V.
Mullick, and et al. 2017 [40] (HAZ) (SR) (SOD) (V) (NA) CO2 3 Al 2024‐T3 sheets.
Riveiro and et al. 2017 [41] (HAZ) (SR) (AGT) (V) CO2 3 Al 2024‐T3 sheets.
El-Wardany And et al. 2018 [44] (KW) (SR) (Pu) (F) (P) CO2 1 AISI 304 St37-2 H.
El-Wardany, H.

The flow rate of argon gas and HMDSO in the liquid phase was controlled by a mass flow controller (MFC) and an EL-Flow (digital mass flow meter and controller), respectively, set at 20 standard cubic centimeters per minute (sccm) and 20 g/hr.
Takai, et al., JOCCA Surf.

Phumying et al. have successfully prepared magnetic oxide nanoparticles by a novel aloe vera extracted solution-hydrothermal method [6, 7].
Lu, E.L.

Samples were then loaded into a vacuum deposition chamber to deposit the 100 nm thick Al cathode.
Jeffries-EL, G.

Yano et al. have studied the synthesis and characterization of nickel (II) and cobalt (III) complexes containing glycosylamines formed by reaction of sugars and diamines[5-7].
C, H and N elemental analyses were measured with a Vario EL Ⅲ Elemental Analyzer.