Search results

You et al. considered an FGM disk with nonlinear material with thermal loading [6].
Kargarnovin et al. ‎[10] investigated a circular FGM disc under symmetrical loading.
Bose ‎[13] & Khanna et al. ‎[14] considered creep in their studies.
Peng et al. studied on an elastic hollow rotating disc with orthotropic material [16].
J. of Mechanics - A/Solids, 72(2018), p.p.298-309 [20] W.Mack, “Rotating el-pl tube with free ends”, Int.

This study's findings are in agreement with Lanzotti et al. [11].
[5] Utela B, Storti D, Anderson R, et al.
Guesses et al.
[7] Turner et al.
[29] Chin Ang K, Fai Leong K, Kai Chua C, et al.

El-Hout, and S.
El-Sheikh, “Preparation and characterization of magnetic photocatalyst from the banded iron formation for effective photodegradation of methylene blue under UV and visible illumination,” J.
Chishti et al., “Synthesis of silver doped Fe3O4/C nanoparticles and its catalytic activities for the degradation and reduction of methylene blue and 4-nitrophenol,” Appl.
Yan et al., “Visible-light degradation of dyes and phenols over mesoporous titania prepared by using anthocyanin from red radish as template,” Int.
Cheng et al., “Synthesis of porous superparamagnetic iron oxides from colloidal nanoparticles: Effect of calcination temperature and atmosphere,” Mater.

Sharma et al. [1] theoretical studied the dynamic performance of journal bearing compensated by slot restrictor for symmetric as well as asymmetric configuration.
Table 1 Principal parameters of the hydrostatic guideways and the restrictor Parameters Value Dimensions of pad(mm) B=50, L=60.5, dr=3 Dimensions of restrictor(mm) d2=8, dc=7.94 Tubing volume(cm3) Vt=8.17 Apparent bulk modulus of the lubricant(MPa) El=1440 Volumetric modulus of elasticity of tube(MPa) Et=∞ Mass of the slide block(Kg) m=7.5 Fig. 4 Amplitude-frequency characteristic of the hydrostatic guideways Amplitude-frequency characteristic of the hydrostatic guideways is plotted in Fig. 4.

The approach is an evolutionary continuation of the work by Germer et al at NIST.
El-Sayed, "Surface-Enhanced Raman Scattering Enhancement by Aggregated Silver Nanocube Monolayers Assembled by the Langmuir-Blodgett Technique at Different Surface Pressures," J.

Chemical Composition (%) Mg Al Zn Mn Fe Cu Si Ni Ca AZ31B Balance 2.98 0.99 0.5 0.0026 0.0005 0.019 0.0005 0.001 Results and Discussion The stress-strain curves for wrought magnesium alloy AZ31B were obtained at various strain rates are shown in Fig. 2.
M., Haithem El Kadiri and Whittington, W.

Implement of the Optimized RN Placement LIN et al. proved that the RN placement is a NP-hard problem [12], and its calculation scale will increase exponentially with the size of the problem.
Cao and E.L.

Harris et al (2008), “ Simulation Support to Capability Engineering”, Proceedings of SimTech-2008, Melbourne,12-15 May, Australia, pp 53-58 2.
El-Hayek, M., van Voorthuysen, E., and Kelly, D., “Optimizing life cycle cost of complex machinery with notable modules using simulation”, Journal of Quality in Maintenance Engineering”, vol. 11, No. 4, 2005.

For example the inlet module can be used as a stand-alone inlet component which can be used to instantiate inlet in the engine model.
In order to use the fuzzy logic for control purposes, a front-end “fuzzifier” and a rear-end “defuzzifier” are added to the usual input-output data set (Mamdani, 1974; Nguyen et al., 1995).

Two ultrasonic foggers (The Mist Maker Model M0001, Mainland Mart Corporation, El Monte, California) were placed in five-gallon buckets filled with water.
Pots were seeded at a rate of 5,382 pure live seed per meter squared (PLS/m2) based on research by Burton et al. (2006), which suggests that higher sowing densities result in more rapid ground cover.