Search results

At present, the improvement of functional properties of soybean protein isolate has been deeply studied by domestic and foreign scholars, including physical modification, chemical modification, enzymatic modification and genetic engineering modification [5, 5,6, 7, 8, 9, 10].
The application of the research results of this project in surimi products can reduce production costs, improve nutritional value, meet the requirements of consumers for low-fat, healthy and delicious products, and has a positive role in promoting the formation of a new profit growth point for enterprises and increasing economic benefits. 1 Materials and Methods 1.1 Materials and Instruments Soy protein isolate as raw material was purchased from Linyi Shansong Biological Products Co., Ltd.
Results and Discussion 2.1 Analysis of Basic Components and Enzyme Activity In order to ensure the quality of raw materials and the activity of enzymes, the basic components of soybean protein isolate (SPI) were determined.
The pH is the key factor affecting the solubility.
Wang, Expression and construction of transglutaminase gene engineering bacteria from Streptomyces mobaraensis, J.

Kerkour El-Miad1,l 1MEGCE group, Laboratory of Materials, Waves, Energy and Environment, Department of Physics, Faculty of Sciences, University Mohamed I, 60000 Oujda, Morocco. 2OAPM group, Laboratory of Materials, Waves, Energy and Environment, Department of Physics, Faculty of Sciences, University Mohamed I, 60000 Oujda, Morocco. 3The Regional Centre for the Professions of Education and Training, Oujda, 60000, Morocco. 4Grupo de Materia Condensada-UdeA, Instituto de Física, Facultad de Ciencias Exactas y Naturales, Universidad de Antioquia UdeA, Calle 70 No. 52-21, Medellín, Colombia.
Farrow, Molecular beam epitaxy: applications to key materials.
Nougaoui, Excitonic properties in an asymmetric quantum dot nanostructure under combined influence of temperature and lateral hydrostatic pressure, Materials Today: Proceedings. 13 (2019) 1023-1032
In Proceedings of the 3rd International Conference on Electronic Engineering and Renewable Energy Systems: ICEERE 2022, 20-22 May 2022, Saidia, Morocco (pp. 263-269) (2023)..
In Proceedings of the 3rd International Conference on Electronic Engineering and Renewable Energy Systems: ICEERE 2022, 20-22 May 2022, Saidia, Morocco, pp. 271-279.

Introduction Manipulators are widely used in engineering fields to raise the productivity and improve the quality of products.
Therefore, they have been widely used in engineering fields, among which tuned mass dampers [2], tuned liquid dampers [3], viscoelastic dampers [4] and impact dampers [5] are the most representative.
Theoretically, impacts can be exactly depicted by means of the modern contact dynamics in mathematics, but it is too complicate to apply in engineering fields.
Samali: Engineering Structures.
Lee: Engineering Structures.

Fluorite, in a range of 2-3%, is usually added in the raw materials to catalyze the MgO reduction reaction [7-10].
Experimental Experimental Materials.
F Contents in Input and Output Materials for the Early Pilot Tests [15].
F in Input Materials and Output Mg Slag for the Present Pilot Tests.
An Mg slag recycling as building materials is important for saving valuable natural resources and decreasing the global warming impact.

Impact Force Spectrum for Damage Assessment of Earthquake-induced Structural Pounding Robert Jankowski1 1 Faculty of Civil and Environmental Engineering, Gdańsk University of Technology ul.
Acknowledgment The study was supported by the European Community under the FP5 Programme, key-action "City of Tomorrow and Cultural Heritage" (Contract No.
Maison: Engineering Structures Vol. 19 (1997), p. 195
[3] Earthquake Engineering Research Institute: EERI Report 95-03 (EERI, USA 1995)
Chopra: Dynamics of Structures: Theory and Applications to Earthquake Engineering (Prentice Hall, USA 1995)

There into, V is an aggregate of every individual unit about product, including products, components, parts and assistant materials etc.
[7] Shuangxia Pan, Fei Gao and Pei’en Feng: Chinese Journal of Mechanical Engineering Vol. 39(2003), p.1-6.
[13] XueHong Du, JianxinJiao and Mitchell M Tseng: Concurrent Engineering Vol. 10(2002), p.113-128
[14] XueHong Du, JianxinJiao and Mitchell M Tseng: Journal of Engineering Design Vol. 14(2003), p.145-167
[15] Zhichun Li and Haijun Huang: Journal of Transportation Systems Engineering and Information Technology Vol. 3(2003), p.28-32.

A New Algorithm for Determining the Optimal Parameters of the Spring of a Slider Cell-Phone Chao-Tsung Leea Hsin-Chuan Kuob Jeun-Len Wuc Department of Systems Engineering and Naval Architecture, National Taiwan Ocean University, Keelung City, 202, Taiwan aaitsung@yahoo.com.tw bkhc@ntou.edu.tw cb0103@ntou.edu.tw Keywords: orthogonal array, non-separable, Rosenbrock function.
The Taguchi method has been widely used for designing high-quality products at low cost in engineering industries because the method provides an acceptable and effective solution.
The properties of the material used for the spring are listed in Table 7.
K.: On Stochastic Optimization, “Taguchi Methods Demystified; its limitation and fallacy Clarified,” Probabilistic Engineering Mechanics Vol. 16, pp.87-101, 2001
D., “Structure Analysis of Stress Concentration Melioration at Hatch Corner by using Key Groove”, Master Thesis, National Taiwan Ocean University, 2002

Mapping the energy flows of coal utilization in China: the methodology and case studies for the year 2005 and 2010 Feifei Yu1, a, Linwei Ma1, b, Lixue Jiang1, c, Zheng Li1, d and Weidou Ni1, e 1State Key Laboratory of Power Systems, Department of Thermal Engineering, Tsinghua-BP Clean Energy Center, Tsinghua University, Beijing 100084, China ayuff06@gmail.com, bmalinwei@tsinghua.edu.cn, cjlx06@mails.tsinghua.edu.cn, dlz-dte@tsinghua.edu.cn, eniwd@tsinghua.edu.cn Keywords: coal utilization; energy flow; Sankey diagram Abstract.
d) Non-fuel use: non-fuel use mainly included coal-derived products used as materials in chemical or other industry. 4) End-use In end-use sectors, final energy included eight kinds of energy carriers: raw coal, cleaned coal, briquettes, coke, gas, other coking products, electricity, and heat.
Non-Fuel use Coal-derived products used as materials in chemical or other industry.
Non-Fuel use Coal-derived products used as materials in chemical or other industry.
[5] IEA: Cleaner Coal in China, 2009, available at http://www.iea.org/textbase/nppdf/free/2009/coal_china2009.pdf [6] Zhou Nan, Fridley David, McNeil Michael, et al.: China’s Energy and Carbon Emissions Outlook to 2050, 2011, available at http://china.lbl.gov/publications/Energy-and-Carbon-Emissions-Outlook-of-China-in-2050 [7] Yongping Yang, Xiyan Guo and Ningling Wang: Energy Vol. 35 (2010), p. 4336-4348 [8] Dongjie Zhang, Pei Liu, Linwei Ma, et al.: Computers and Chemical Engineering Vol. 37 (2012), p. 227-247 [9] Qiang Liu, Minjun Shi, Kejun Jiang: Energy Policy Vol. 37 (2009), p. 2440-2449 [10] Yue Li: Energy Policy Vol. 51 (2012), p. 138-142 [11] Hezhong Tian, Cheng Ke, 2010 International Conference on Electrical Engineering and Automatic Control (ICEEAC 2010) Vol 6 (2010), p. 501-504 [12] Kechang Xie, Wenying Li and Wei Zhao: Energy Vol. 5 (2010), p. 4349-4355 [13] Fang Rong, David G.

Numerical Simulation of the Mechanically Pumped Two-Phase cooling loop LIU Jie, ZHOU Enze,ZHAO wenjun and CHENG cheng Institute of Environmental and Municipal Engineering, QingDao Technological University ,China lujor@163.com Key words: thermal control; mechanically pumped cooling loop (MPCL); Sinda/Fluint; two-phase fluid Abstract.
Generally speaking, the circulation medium should have good thermal stability, chemical, steam pressure is neither exorbitant nor too low in operating temperature range, at the same time considering the safety, it also should match with tube shell and system components material.
References [1] Yu.F.and Maydanik: Review Loop heat pipes, Applied Thermal Engineering, 25 (2005) 635–657
Applied Thermal Engineering, 23 ( 2003) :1099–1108
Birur: NASA thermal control technologies for robotic spacecraft, Applied Thermal Engineering 23 (2003) :1055–1065

The Discussion on the Construction of City Waterfront Landscape Based on the Visual Angle of Ecology Restoration Guiyuan Li 1,a, Zhongyuan Duan 2,b and Yang Xu 2,b 1 College of Civil Engineering and Architecture of China Three Gorges University Wuhan Hubei China 2College of Civil Engineering and Architecture of China Three Gorges University Yichang Hubei China 2College of Chemistry and Life Science of China Three Gorges University Yichang Hubei China algy@ctgu.edu.cn , bduanzhong_yuan@126.com, b402794554@qq.com Key words: Waterfront Landscape; Ecology Restoration; Landscape Ecology Pattern; Artificial Wetland.
The concept of ecology restoration and theory.The ecology restoration means that, based on ecology principle, through certain technology and method of biology, ecology and engineering, artificially changes and cuts off the leading factor and process of ecosystem degradation, adjusts, configures or optimizes flow processes and space-time order of material, energy and information inside and outside the system, restoring the ecosystem structure, function and ecology potential certain or original even higher level [2].
According to this, the use of wetland restoration technology, (i.e. through the ecology technology or the ecology engineering, the degenerate or vanished wetlands are repaired or rebuilt to reproduce the physical, chemical and biological characteristics before disturbance, so that the the proper role is played.) [4] restores ecology wetland landscape depending on the hill, and the use of physical, chemical and biological triple co-ordination role of the matrix - - microorganism - - plant compound ecosystem achieves the efficient purification of sewage, through filtration, adsorption, precipitation, ionic exchange, plant absorption and microorganism decomposition.