Search results

In addition the ferrous iron was extremely cheaper than all the other Al(III) and Fe(III) agents.
[12] N El Azher, B Gourich, C Vial: Chem.

Impact Of The Strain Rate During Tension Test On 46Cr1 Steel Temperature Change LIPSKI Adam The University of Technology and Life Sciences in Bydgoszcz, Faculty of Mechanical Engineering, Al.
-S., Johnson S., El-Hajjar R.: Thermoelastic and infrared-thermography methods for surface strains in cracked orthotropic composite materials.

Experimental The material used in this investigation is a HSLA steel sheet of the grade ZStE 500 (0.07 wt% C, 0.71 wt% Mn, 0.1 wt% Cr, 0.047 wt% Si, 0.034 wt% Nb and 0.016 wt% Al) with a thickness of 2 mm, designed for deep drawing.
Landersheim, C. el Dsoki, P.

(Barrett et. al., 1973; Ashby & Jones, 1994).
Retrieved on March 22, 2006, from http://www.isixsigma.com/syndicate/ email:kcrow@aol.com [10] Taguchi, G., El Sayed, M. & Hsaing, C. (1989).

Table 1– Chemical compositions of Ni-Ti alloys El.
Ni Ti Al Cu V etc.

Ayub et al. [6] recently investigated the behavior of HPFRC containing 1, 2 and 3% volume of the PVA fibers and reported the improvement in the mechanical properties, specially splitting tensile strength and flexural strength at higher fiber volume of 3%.
El-Kashif, K.

. %) Element Mg Si Cu Zn Ti Mn Cr Al Amount (Wt %) 0.85 0.68 0.22 0.07 0.05 0.32 0.06 Balance The initial joint configuration was obtained by securing the plates in position using mechanical clamps.
The format of L9 orthogonal array was presented in Table 3.The quality characteristics such as ultimate tensile strength (UTS), yield strength (YS), percentage of elongation (% EL), and impact toughness (IT) of AA 6061 Aluminum alloy were evaluated for all the trials and then statistical analysis of variance was carried out.

El-Sayed, S.
Al-Showiman , N.

El-Bagoury, Mat.
Ashby and A.L.

Reference [1] K.M.Abou El-Nour, A.Eftaiha, A.Al-Warthan, R.A.Ammar, Synthesis and applications of silver nanoparticles, Arabian J Chem. 3 (2010) 135–40