Search results

Lohfeld, etal: Journal of the Mechanical Behavior of Biomedical Materials Vol. 3(6) (2010), p. 63
Javad: Tsinghua Science & Technology Vol. 14(6) (2009), p. 108

Effect of the angle between optical fiber and adjacent layer on the mechanical behavior of carbon/epoxy laminates with embedded fiber-optic sensor, Journal of Materials Science Letters,20000915, Volume 19, Issue 18, pp 1673-1675 [6] R.

Investigation the Performance of Axial Channel Rotor in Inset Permanent Magnet Synchronous Machine Jeeng-Min Linga, Tajuddin Nurb Department of Electrical Engineering, Southern Taiwan University of Science and Technology, Taiwan ajmling@mail.stust.edu.tw, bnasir_tan76@yahoo.com Keywords: Axial channel rotor, Inset Permanent Magnet, Normal flux density, Magnetic flux distribution, Rotor core area Introduction.
The lighter rotor can be done by using a light material or conventional material, such M-19, with axial channel system, so that rotor mass be reduced.
Sanavullah, "Magnetic Parameters and Torque Analysis of Exterior Rotor Permanent Magnet Brushless DC Motor by Finite Element Method," European Journal of Scientific Research, Vol.71, No.4, pp. 561-568, 2012

Table 1 Material Parameters Material E（MPa） ν ρ （kg/m3） β （°） Ψ (°) K Roadbed soft 25 0.3 1900 29.5 29.5 1 weak soil 4 0.35 1700 34.5 34.5 1 Clay 22 0.28 1900 38 0 1 Gravel 48 0.2 2100 32.8 0 1 Abutment 25000 0.2 2400 — — — Bored pile 28000 0.2 2400 — — — Mixing pile 110 0.25 2200 — — — Numerical model results analysis The abutment embankment near the side of the front row of piles called piles will be away from the embankment side of the row of piles called back pile.
References [1] Zhao Limin Soft Abutment Analysis and integrated approach [J] Railway Science and Engineering, 2006, 3 (4): 54-58.In Chinese
[5] Liren Ping, CHEN Yun-min, Ren-Peng Chen affect bridge embankment on soft ground near pile analysis [J] Chinese Journal of Highway, 2001, 14 (3): 73-77.In Chinese

Materials and Experiment Diethanolamine was purchased from Merck with purity of 99%.
International Journal of Sociology and Social Policy, 2003. 23(10): p. 74-105
Environmental Science & Technology, 2002. 36(20): p. 4467-4475

Three potential cell damage areas Materials and Method Experiment system.
Annals of the New York Academy of Sciences[J]. 369: 47-59
Journal of Fluid Mechanics. 254: 437-466.

Turkis: Maintenance strategy selection using AHP and COPRAS under fuzzy environment, International Journal of Strategic Property Management, Vol. 16 (2012), p. 85-104
Tang: Research on modeling method for equipment maintenance strategy based on reliability and residual life, Applied Mechanics and Materials, Vol. 215-216 (2012), p. 817-825
Kinney: Expert Judgment Assessment of the Mortality Impact of Changes in Ambient Fine Particulate Matter in the U.S., Environmental Science and Technology, Vol. 42 (2008), p.2268-2274

Yu Xianzhong (2010) made the fatigue analysis, which based on the fatigue breaking of the differential case of the drive axle with the material of nodular graphite cast iron.
They found that the reason of the failure of the differential case could be sure that the stress concentration was at the region of the differential shaft hole in the differential case, and the safety factors were beyond the safe yield limit of the material QT450-10.Huang Fengyun (2012) carried out the researches on the meshing vibration of main reducer gear monitored by gear matching machine，and the vibration signals analyzed by MATLAB.
Acknowledgements The authors express their gratitude to the Natural Science Foundation of China (50875022) for the financial support of the study.
Journal of Wuhan University of Technology, 2012, 34(3): 301-305.

Introduction Gudao oilfield is a typical fluvial facies sedimentary, sand body change is big, stratigraphic division and correlation of the difficulty of the bigger; Secondly, the field of thick oil density, viscosity change is bigger, try oil, exploration material is less; Recovery time is long, and the well number, each well water flooded the different stages, it is difficult to in a short time in every Wells are fine log interpretation, so as to better determine the sand body oil type, oil-water relationship and oil-water boundary problems.
Such as B113 well Ng 55 and Ng 56 small layer core can be observed scour mark, then combined with adjacent well material, can be split into the sand body Ng 55 and Ng 56 two small layer（Figure 1）.
Acknowledgments This study was supported by the National Natural Science Foundation of China (41202081).
[2] LIU Luofu, WANG Weili, JIANG Zhenxue, et al: Characteristics of the Ordovician Carbonate Reservoir Beds in Tazhong Areas of Tarim Basin and Hydrocarbon Accumulation, Journal of China University of Mining & Technology[J] .2010, 39(3), 395-401+407

An Industry Temperature Measurement Zigbee Node Design Chundong She1,a, Siquan Hu2,b and Hui Yao3,c 1School of Electronic Engineering, Beijing University of Posts and Telecommunications, Beijing, 100876, China 2School of Computer and Communication Engineering, University of Science and Technology Beijing, Beijing, 100083, China 3 Ruijie Networks Co., Ltd, Beijing, 100036, China ascd@bupt.edu.cn, bhusiquan@ustb.edu.cn, cyaohui@ruijie.com.cn Keywords: Industry temperature measurement; Thermocouple; Zigbee node Abstract.
A thermocouple sensor consists of two conductors of different materials (usually metal alloys) that produce a voltage in the vicinity of the point where the two conductors are in contact.
Ahamed: Journal of Theoretical and Applied Information Technology, Vol. 5, No.2 (2009), p.129 [5] G.Hu: International Conference on Computer Engineering and Technology (ICCET), Vol.7 (2010), p. 560 [6] CC2530 on http://www.ti.com/product/cc2530 [7] D.