Search results

Acknowledgements This paper is supported by the National Natural Science Foundation of China (Grant No. 41172298 ).
Advanced Materials Research, Vol. 734-737(2013),p.791-795
In Chinese: Chinese Journal of Rock Mechanics and Engineering.

Development of Hot Rolled Strips for Internal Plates of Automobile Xingdong Peng1, a﹡, Meiling Wang1, b, Shengli Li1, c and Jie Xu2, d 1School of Material and Metallurgy, University of Science and Technology Liaoning, 185 Qianshan Road, Anshan 114051 China 2Technical Center, Tangshan Iron and Steel group Co.Ltd., 9 Binhe Road, Tangshan, 063016, China.
Fatigue experiments were conducted by material testing simulation machine (MTS) 810（10t）and tensile-tensile fatigue performance testing was measured: some parameters were set as follows: R＝0.1, fatigue test cycle was 30 Hz, fatigue stress waveform was sine wave, according to national tension-tension fatigue test standard (GB3075-82).
[6] S.L.Li, N.Li, X.D.Peng, X.Y.Lv, J.G.Li, Fatigue property of hot rolled and cold rolled strips, Journal of Iron and Steel Research. 2 (2013) 48-51.

With the development of science and technology, tunable optical fiber system will be bound to a rapid development and wide application [4].
System Implementation Material Selection of the System.
Fig.7: OTDR photo of access fiber of 2km+4km Conclusions This paper has presented a tunable optical fiber system from material selection, design and test.
“Optical-signal-processing device based on waveguide-type variable delay lines and optical gates”, Journal of lightwave technology, 2006(24), 2593-2061

As the discrepancy between the development speeds of the two systems became smaller, the coupling degree was closer to 45°, and the two systems were becoming better coordinated.[5] The cause analysis of environment and resources problems Shenyang metropolitan area is the heavy chemical industry concentrated area, is the important equipment manufacturing industry and raw materials production base, and is one of the worst environmental pollution areas.
Ecology and Environmental Sciences 2010, 19(3): 718-723
[5] Han Ruiling, Tong Lianjun, Tong Weiming, Yu Jianhui: Coordinated evolvement of dynamic coupling between economic and environmental systems in Shenyang Metropolitan Area[J] Chinese Journal of Applied Ecology 2011,22(10): 2673-2680.

Under the hinterland of the Junggar Basin in the thick Cenozoic sedimentary developed more the consecutive complete the late Paleozoic strata, these strata contain clastic sedimentary rocks, and also contains part of the magmatic rocks, to explore the basement nature of the Junggar basin, basin hinterland late Paleozoic source district changes and the corresponding tectonic evolution provides the ideal material.
Laser ablation-multicollector plasma mass spectrometry (LA-MC-ICPMS) can also be in situ determination of zircon Hf isotope compositions provide unique constraints for zircon Hf source (such as a depleted mantle and evolution of the earth's crust), zirconium stone of Ti thermometer to determine the temperature of formation of zircon, zircon oxygen isotopes to determine whether the zircon from recycled crustal material.
Journal of Asian Earth Sciences.

The boundary conditions and the materials are also shown in the figure.
Acknowledgement This research has been supported by the National Natural Science Foundation of China (No. 61005072), Self-Planned Task (No.
Jacot: Journal of Micromechanics and Microengineering Vol.16 (2006), p. 1267 [2] V.

Chang: Automation Application, Vol. 11(2011), p.16 [2] X.D.Wang, B.Y.Xu and S.B.Zhong: Applied Mechanics and Materials Vol. 143 – 144 (2011), p. 139 [3] X.Z, L.Z.Zhang: Science & Technology Information Vol. 1 (2010), p. 76 [4] Ji Z N 2006 B.
DSP practical techniques and application examples. 1202 [5] Liu G F, Peng H and Zhao T F 2008 J.Editorial Office of Chinese Journal of Scientific Instrument. 2608

Study on electrochemistry property of Ferric(III)-Oxalate-Gluconate Complex and Its dyeing application Dan Yu1,2,a* , Jie Yang1,b, Chong Qian1,c, Jia Jia Zhang1,d, Wei Wang1,e 1College of Chemistry, Chemical Engineering and Biotechnology, Donghua University, ShangHai 201620 2Key Laboratory of Science & Technology of Eco-Textile(Donghua University), Ministry of Education,ShangHai 201620，China ayudan@dhu.edu.cn,byangjie_xiu@163.com,cqianchong126@126.com,dzjjfendou2011@163.com, ewangv@dhu.edu.cn.
Experimental Materials and methods.
Journal of Applied Electrochemistry.2004, 34, 1221-1227

Then the red (R), green (G), blue (B) OLED materials were deposited on substrates by the ink-jet printing, and the silver electrode was deposited by vacuum deposition thermal evaporation method.
Science Report 4, 4124 (2014). https://doi.org/10.1038/srep04124 [7] Jaeseob Lee, Jin-Seong Park, et al.
Journal of Applied Physics 74, 381-386 (1993) https://doi.org/10.1063/1.354121 [11] Han, Yun & Jeong, Eun Gyo & Kim, Hyuncheol & Kwon, Seonil & Im, Hyeon-Gyun & Bae, Byeong-Soo & Choi, Kyung.

The incorporation of DID concept and risk insight into deterministic based safety inspection has not been well studied so far since the regulatory safety inspection was developed depending on each country’s specific regulation In general understanding, PRA is described by the series of event trees (ET) that get initiated from an initiating event; therefore, it is essential to associate the relationship conceptually between the 3 levels of PRA with the 5 levels of DiD as define by IAEA [2] in Fig. 2 Fig. 2 Relationship between PRA and DID [3] To ensure the safety of nuclear power plants, the control of reactivity, removal of heat from the core, and restriction of radioactive materials should be performed.
[8] Rahman Khalil Ur, Jinsoo Shin, Muhammad Zubair, Gyunyoung Heo, and Hanseong Son, 2013, “Sensitivity Study on Availability of I&C Components Using Bayesian Network” Science and Technology of Nuclear Installations [9] M.
Khan, (2011) “Calculation and Updating of Reliability Parameters in Probabilistic Safety Assessment” Journal of Fusion Energy [10] Saud BinKhadim, Muhammad Zubair, (2019) “calculations of risk parameter for safety injection system (SIS) in APR1400, in case of large LOCA” The Proceedings of the International Conference on Nuclear Engineering (ICONE) 2019.27:1381.