Search results

Prewencja i rehabilitacja 4/2004, pp. 2-3, ISSN 1731-8971 (in Polish) [9] http://rehabilitacionymedicinafisica.wordpress.com/2009/06/26/historia-y-futuro-de-la-rehabilitacion-el-oplomoclion-zander-pilates-y-los-exoesqueletos-robot/ [10] Krebs H.I. et al.
S., et al.

Other details are not usually required because they add to the complexity without improving realism, however some simulators provide a detailed physics or engine models; these are useful when investigating emissions or the detailed effects of impact [5]. 2: Modeling drivers Paruchuri et. al [6] suggested that the decisions drivers have to make can be split into micro and macro goals.
They also thank Ayman El-Dabh for providing them with a number of Egyptian traffic surveys.
[8] AL-Shihabi, T. and Mourant, R.R., 2001.

Yang et al. [31] investigated the thermal ageing of the epoxy/anhydride binder DGEBA/MeTHPA/DMP-30 in a ratio of 100:80:2 (a complete analogue of the EDI binder), which was cured at 120°С for 90 min and then at 150°С for 90 min.
Lu et al. [32] examined properties of pultruded BFRP specimens made of the same binder and basalt roving with a monofiber diameter of 15.5 µm.
El-Safty, S.H.

This percentage is not too far from Mahmoud et al. result which was 60% [30].
[18] Reyes, V. et al.
El-Haroun, E.

Taha 1,a , Gerhard Ziegmann 2,b 1 Faculty of Engineering, Ain Shams University, El-Sarayat Str. 1- Abassia, Cairo, Egypt 2 Institute for Polymer Materials and Plastics Engineering, Clausthal University of Technology, Agricolastrasse 6, 38678 Clausthal-Zellerfeld, Germany a iman_taha@eng.asu.edu.eg, bZiegmann@puk.tu-clausthal.de Keywords: biodegradable polymers, polylactic acid, polyvinyl alcohol, natural fibres, mechanical behaviour, SEM Abstract.The application of natural fibres as polymer reinforcement is of extreme interest, especially in combination with biodegradable polymers.
Arbelaiz et al [10] related the similarly low values of IFSS in the case of a polypropylene system to a week fibre-matrix adhesion, as initially assumed.
Ray et al. reported similar observations and proposed that the fibres act like flaws in the matrix, when the volume fraction of reinforcing fibres is lower than a certain critical quantity [12].

Bakis et al., Fiber-Reinforced Polymer Composites for Construction—State-of-the-Art Review, Journal of Composites for Construction, vol. 6 (2002) pp. 73-87
Bazant et al., Wake-up call for creep, myth about size effect and black holes in safety: What to improve in fib model code draft, presented at the fib symposium Prague 2011, Prague, 2011
Cannon, The analysis of time dependent effects of reinforced concrete systems through in-situ structural health monitoring, presented at the Global Thinking in Structural Engineering: Recent Achievements, Sharm El-Sheikh, Egypt, 2012

El Minor, A.
Al Gaoudi, Mechanical and thermal properties of bio-composites based on polypropylene reinforced with Nut-shells of Argan particles, Mater.
[16] A.L.

Wang et al examined the role of miRNA-17-92 in differentiation of mouse preadipocyte 3T3L1 cell.
Cawthorn, E.L.
Brown, A.L.

. %) of PCS Element C Si Mn P S Cu Ni Al Fe Composition 0.40% 0.17% 0.44% 0.01% 0.01% 0.08% 0.01% 0.03% Balance Electrodeposition bath The acid chloride electrolyte bath comprises of ZnCl (71g/l), KCl (207g/l) and H3BO4 (35g/l). which acted to sustain the pH value of the electrolyte.
Al-Deyab, R.
El Ouadi, M.

An Elementar elemental analyser (Vario EL III) was used to analyse organic elements after the tested samples were dried.
Actually, Okuda et al [11] achieved fairly good consistency to the products from hydrothermal disassembly of lignin by substituting its C3 units with glycerol, which supported the cleavage of propyl branched chains from aromatic structures; Further, Kishida et al [12] have verified that lactic acid can be produced from glycerol under hydrothermal conditions at the presence of alkali.