Evaluation on some Properties of SL7560 Type Photosensitive Resin and its Fabricated Parts

Abstract:

Stereolithography technique is dealt with the techniques of machinery, laser, numeral control, computer software and photosensitive resins, etc. The quality of the photosensitive resins has direct effect on the dimensional accuracy, mechanical properties of the fabricated parts. Therefore the further research on SL7560 type photosensitive resins is very meaningful and valuable. The properties of SL7560 type photosensitive resin were investigated by some instruments and equipments. Characteristics of FT-IR showed that SL7560 type photosensitive resin belonged to an epoxy-acrylic hybrid photosensitive resin. The experimental results showed that its viscosity at 30°C was 197mPa.s, its critical exposure (E_c) was 5.9mJ/cm2, its penetration depth (D_p) was 0.14mm, the tensile strength of its cured product was 43.7MPa, the tensile modulus was 2549MPa, the elongation at break was 10.7%. With the photosensitive resin as the processing material, the part of a mobile phone shell was fabricated using the Stereolithography Apparatus (HRPL-I), and the quality of the fabricated part was good.

• Periodical: Applied Mechanics and Materials (Volumes 117-119)
• Pages: 1164-1167
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.117-119.1164
• Online since: October 2011
• Authors: Bi Wu Huang, Ming Yi Chen
• Keywords: Laser, Photosensitive Resin, Property Analysis, Stereolithography

References

[1] Alfonso Maffezzoli, Roberto Terzi: Thermochimica Acta Vol.321 (1998), p.111

[2] Ben Luan, Xing Yang Liu, John Nagata and Woo-Jae Cheong: Surface & Coatings Technology Vol.192 (2005), p.323

[3] Dickens PM: J. Eng. Manuf. Vol.209 (1995), p.261

[4] J.Y.H. Fuh, Y.S. Choo and L.Lu: J. Mater. Process. Tech. Vol.63 (1997), p.887

[5] D.E. Karalekas and A.Agelopoulos: Materials and Design Vol.27 (2006), p.100

[6] Huang Biwu, Chen Weifan and Chen Weiqing: ACTA OPTICA SINICA Vol.28 (2008), p.2354 ( In Chinese)

[7] G.V. Salmoria, P. Klauss and A.T.N. Pires: Polymer Testing Vol.27 (2008), p.698

[8] G.V. Salmoria, C.H. Ahrens and V.E. Beal: Materials and Design Vol.30 ( 2009), p.758

[9] Yi Chao: Macromol. Mater. Sci.& Eng. Vol.20 (2004), p.184 ( In Chinese)

[10] C.M. Cheah, A.Y.C. Nee, J.Y.H. Fuh, et al.: J. Mater. Process. Tech. Vol.67 (1997), p.41