Deep-Hole Single-Edge Technology Test of Rigid Reamer

Abstract:

Single-edge rigid reaming process has high-speed cutting rigid hinge processing, auto-oriented, low surface roughness of a series of advantages. In this paper, by using of the elastic and plastic theory, we studied the effect of the force acting on the guide block extrusion on the hole wall, proposed the two different cutting states of single-edge rigid reaming processing, and analyzed the conditions of the reaming processing in the extrusion state. By the analysis of experiments, we obtained that in order to achieve the good hole processing surface quality we must make the reaming processing in the extrusion processing state, and we determined the impact of the cutting parameters on the cutting force and surface roughness.

• Periodical: Applied Mechanics and Materials (Volume 120)
• Pages: 296-303
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.120.296
• Online since: October 2011
• Authors: Xing Quan Shen, Yao Ming Li, Hai Jiao Zhang
• Keywords: Deep Hole, Process, Single-Blade Reamers Rigid, Test

References

[1] Tiebin Fan, Hongwei Pei, edited by Tool Engineering, in Chinese Vol.31(2009):pp.25-27.

[2] C S Deng，J H Chin, edited by International Journal of Advanced Manufacturing Technoloy, Vol.25(5-6) (2008), pp.420-426.

[3] P.Rau, M.SS. hunmugam, edited by Wear, Vol. 124(l)(2008), pp.33-43.

[4] R. Landers , A. Ulsoy, edited by ASME International Mechanical Engineering Congress and Exposition, Atlanta, Georgia, November, Vol. 58(2006), pp.183-190.

[5] J H Chin, R J Jiang, edited by Proceedings of the JASTED International Conference on Modeling, simulation and Optimization(2009), pp.52-56.