The Embedded Design of Vibrator Sweep Signal Generator Based on ARM9

Yuan Yuan Shen; Gong Ming Zheng

doi:10.4028/www.scientific.net/AMM.229-231.1527

Paper Titles

The Research and Design of Card Reader Based on RFID
p.1511

A Digitally Controlled Oscillator for ADPLL Application
p.1515

Process Antenna Effect Elimination in Ultra Deep Submicron
p.1519

Research on FPGA-Based Three-Level Power Amplifier for Active Magnetic Bearings
p.1523

The Embedded Design of Vibrator Sweep Signal Generator Based on ARM9
p.1527

A Novel High-Pass Filters Implementation by Fully Differential Op Amp Integrators
p.1531

Calculation of the Transmission Frequency and Modulation Based on PD5000
p.1535

The Key Techniques on Micro-Assembly of Micro-Radio Modules
p.1539

Design of Data Transfer System Based on PCI Express Interface Applied in High-Speed Railway
p.1543

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vols. 229-231The Embedded Design of Vibrator Sweep Signal...

The Embedded Design of Vibrator Sweep Signal Generator Based on ARM9

Abstract:

This paper presents the embedded design of sweep signal generator which is based on ARM9+Linux platform. It describes DAC712 device dentally and prepared a DAC driver and upper application. Finally, the test signals generated by the system obtained the test results and the results were analyzed.