Identification of Toolholder-Spindle Joint Based on Receptance Coupling Substructure Analysis

Li Jun Zhai; Xiao Lei Song; Li Gang Cai

doi:10.4028/www.scientific.net/AMM.345.539

Paper Titles

Influence of Three-Dimensional Stability Lobes on the Cutter Design
p.521

Static Analysis on the Measurement System of an Electronic Belt Scale
p.525

Design of Two-Welding Torch Automatic Welding Machine
p.530

The Analysis of the Automatic Steel Drum Tilter
p.534

Identification of Toolholder-Spindle Joint Based on Receptance Coupling Substructure Analysis
p.539

The Semi-Automatic Drilling Machine for Flange Processing
p.543

Research on Decision Support System of Relay Protection Equipment Status Evaluation Based on Mechanical Overhaul
p.547

The Finite Analysis and Optimization of Gantry Beam on Automatic Welder
p.553

Finite Element Analysis of the Frame of Straightening Machine with Twelve Rolls for Tubes
p.557

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vol. 345Identification of Toolholder-Spindle Joint Based...

Identification of Toolholder-Spindle Joint Based on Receptance Coupling Substructure Analysis

Abstract:

Stiffness identification of toolholder-spindle joint is a basic work for machine tool dynamic research. In this paper, an identification method based on receptance coupling substructure analysis is described. Once the frequency response functions of the toolholder, the spindle and the toolholder-spindle assembly are obtained, the analytical stiffness could be calculated. The method is verified efficiency through dynamic response experiment. Identified stiffness results under different drawbar forces are also discussed.