Design of Injection Mould for Cars’ Interiors Based on CAD/CAE Technology

Yan Juan Li

doi:10.4028/www.scientific.net/AMM.44-47.1708

Paper Titles

Impacting Analysis on the Coupler and Buffer of a Subway Vehicle for the Shunting Operations
p.1687

Kinematics and Strength Analysis on Variable Propeller Pitch Mechanism of a Wind Turbine Generators
p.1693

A New Spurts Controllable Electrospinning Collecting Device Designed Basing on Advanced Motion Control
p.1698

Modeling and Simulation for Dual-Drive Transmission System of TBM Based on Bond Graph
p.1703

Design of Injection Mould for Cars’ Interiors Based on CAD/CAE Technology
p.1708

Study on Realtime Information Integrating System Orienting Enterprise
p.1713

Analysis of Three-Phase Power Transformer Inrush Current Magnetic Field
p.1719

Comparison on Simulation and Experiment of Supply Air through Metro Vehicle Air Conditioning Duct
p.1724

Analytical Solution to Excited Waveform of Bias Control on Electro-Hydraulic Vibration Exciter
p.1729

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vols. 44-47Design of Injection Mould for Cars’ Interiors...

Design of Injection Mould for Cars’ Interiors Based on CAD/CAE Technology

Abstract:

The structural features of the cars’interiors were analyzed. A solid model about the cars’interiors and the injection mould were put up by using UG three-dimensional sculpting technolgy and using Moldflow software to analyze and simulate injection progress for the plastic part. The results showed that the use of CAD/CAE technology could assure the veracity of the injection mould effectively, shorten the design time of the part, reduce the time of trying mould, decrease the manufacturing cost and these could enhance the competion ability of the corporation in the market.

You might also be interested in these eBooks

Frontiers of Manufacturing and Design Science

View Preview

Info:

Periodical:

Applied Mechanics and Materials (Volumes 44-47)

Pages:

1708-1712

DOI:

https://doi.org/10.4028/www.scientific.net/AMM.44-47.1708

Citation:

Cite this paper

Online since:

December 2010

Authors:

Yan Juan Li

Keywords:

Injection Mould, Moldflow, Parting Line, Surface, UG

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

Citation:

References

[1] Changyin Gao, Cheng Zhao , Jinfeng Wang. UG mold design from start to proficient[M]. publishing house of electronics industry. (2007).

Google Scholar

[2] Zhu Ji , Zhang Zeng, Zhang Jie, Lei Yan-wei. Design of injection mould for plastic articulated type bottle cap based on CAE analysis. Die& Mould Industry, Vol. 36(2008) pp.354-359.

Google Scholar

[3] Technology, Shanghai College of Transport & Communications, Shanghai Maritime University. Application of rough set theory in injection molding, Die & Mould Industry; 2007-05.

Google Scholar

[4] Xu Jian-wen Liu Bin. Design and Optimization of Cooling System for Injection Mould Based on Moldflow. Plastics Science and Technology. Vol. 36(2008), p.203.

Google Scholar

[5] Brahimi B, Aitkadi A, Ajji A. Weldline and mechanical p roperties of injection molded polyethylene /polystyrene / copolymer blends. Polym Eng Sci, 1994, Vol. 32(1994), p.1202.

DOI: 10.1002/pen.760341506

Google Scholar