Influence of Ball Milling Parameters on Preparation of Ti50Cu23Ni20Sn7 Amorphous Alloys Powder

Ge Wang; Qiang Li; Ying Gao; Jing Na Gao; Yu Ying Zhu; Zhi Gang Chao

doi:10.4028/www.scientific.net/AMM.55-57.819

Paper Titles

Model and Control of Nitrogen Releasing of Lakes’ Sediment
p.796

The Application Research of Amplitude Spectrum in the Coating Layer Thickness Detection
p.802

Modeling the Loading-Rate Dependency of the Hysteretic Dynamics of Magnetorheological Dampers
p.807

A Control System Based on the Fuzzy Self-Tuning PID Controller for Three-Phase Rectifier
p.813

Influence of Ball Milling Parameters on Preparation of Ti₅₀Cu₂₃Ni₂₀Sn₇ Amorphous Alloys Powder
p.819

Kinematic Analysis of Power Drive Transmission System of High-Performance Four-Wheel Off-Road Vehicles
p.825

Effects of Al-5Ti-B-2RE on the Microstructures and Mechanical Properties of Al-10Mg Alloy
p.828

Effect of Dressing Load and Speed on Removal Rate in the Chemical Mechanical Polishing Process
p.832

Measure Method on Reaction Time of Visual Attention Using a New-Style Mechatronic Measurement System
p.838

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vols. 55-57Influence of Ball Milling Parameters on...

Influence of Ball Milling Parameters on Preparation of Ti₅₀Cu₂₃Ni₂₀Sn₇ Amorphous Alloys Powder

Abstract:

Ti₅₀Cu₂₃Ni₂₀Sn₇ amorphous alloys powder was prepared by mechanical alloying (MA) in a high-energy planetary ball mill. Milling parameters such as rotational velocity of ball mill, ball to powder weight ratio as well as milling time were throughly investigated. Mechanism of mechanical alloying was throughly discussed.