Research on the Material Model of Cold Deformation Strengthened Steel

Tie Shan Zhang; Hui Hui Luo

doi:10.4028/www.scientific.net/AMM.610.967

Paper Titles

Downsampling Direct Sequence Spread Spectrum Signal Using Orthogonal Pretreatment
p.944

The Loss Rate Analysis of Information Packet in Bi-Directional Cable TV Network
p.949

Dynamical Traffic Engineering in Software-Defined Network
p.954

Triboluminescent Material for Short Wave Emission Effect and the Tribological Mechanism
p.961

Research on the Material Model of Cold Deformation Strengthened Steel
p.967

Mathematical Programming Combined with Cascade Analysis in Refinery Hydrogen Networks Including a Purifier
p.972

Degradable Scaffold Microstructure of Artificial Bioactive Bone Fabricated by 3D Braiding Method
p.980

Structural Properties, Modeling and Optimization of Tribological Behaviors of Plasma Sprayed Ceramic Coatings
p.984

2-D Transient Radiative Heat Transfer Analysis on the Slab in a Walking-Beam-Type Reheating Furnace
p.993

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vol. 610Research on the Material Model of Cold Deformation...

Research on the Material Model of Cold Deformation Strengthened Steel

Abstract:

The material model of cold deformation strengthened steel were studied. Firstly, on the basis of primary analysis for the material model, two assumptions are brought out. Then, on the basis that the residual stress and grain boundary state are detected, the constitutive equations are established by using affine transformation strain method.