Study on Phenolic Foams Modified by Graphene Oxide

Jin Peng Luan; Xin Fang Wei; Xue Ping Zhou; Guo Zhong Lu; Chen Zhao Liu; Guo Dong Li; Ya Xin Na; Hai Wang Wang; Xi Wei Qi

doi:10.4028/www.scientific.net/AMR.1095.510

Paper Titles

Non-Linear Finite Element Analysis on Rubber O-Sealing Ring of SRM
p.490

Preparation Method and Device of Microcellular Sheet Based on Batch Foaming
p.495

The Effect of Laser Power Density on Laser Covered Graphene
p.501

Elastic-Plastic Constraints Analysis for Hole-Edge Crack
p.505

Study on Phenolic Foams Modified by Graphene Oxide
p.510

Experimental Research about Polyester Viscose Seat Fabric Water and Oil Repellent Finishing
p.514

An Experimental Study of Compatibility for Metallic Inserts Bonded into CFRP Laminates Soaked in Aircraft Fuel
p.518

The Method of Two-Dimensional Stretching to Reduce Residual Stress in Quenched Thin-Walled Aluminum Alloy
p.523

Application Reseach of Oriental Silicon Steel Sheet Used in the Table Motor
p.527

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 1095Study on Phenolic Foams Modified by Graphene Oxide

Study on Phenolic Foams Modified by Graphene Oxide

Abstract:

After the primary exploration of the preparation procedure of phenolic foam, we studied the modification of phenolic foam by graphene oxide. According to our researches we found that the influence of modifier to the percentage of close area was very little, but it can greatly decrease the thermal conductivity of phenolic foam. In this way, phenolic foam thermal conductivity can be reduced to 0.025 W/m^.K.