Modeling of Flow Stress of Spray-Forming FGH95 Superalloy under Hot Compression

Biao Guo; Sui Cai Zhang; Chang Chun Ge

doi:10.4028/www.scientific.net/AMR.510.154

Paper Titles

Parameterized Modeling and Finite Element Analysis of the Support of Precalciner
p.132

Conceptual Design of an Automatically Replacing and Charging System for Electric Vehicles
p.136

Control of the Flight Vehicle Cable over Wide Spectrum Radiation Effects Simulation Experiment Research
p.141

In-Plane Cushioning Optimization of Multilayer Regular Triangular Honeycombs
p.147

Modeling of Flow Stress of Spray-Forming FGH95 Superalloy under Hot Compression
p.154

The Effect of Lashing Wire Location on Mode Localization of Mistuned Bladed Disks
p.160

The Structure Design of the Mechanical Clamping Claw of the Automatic Arranging Drill Pipe System
p.165

Research on the Memory Cutting Model of Shearer
p.170

Screen-Printing-Based Fabrication of Silver Patterns on Polyimide Substrate
p.176

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 510Modeling of Flow Stress of Spray-Forming FGH95...

Modeling of Flow Stress of Spray-Forming FGH95 Superalloy under Hot Compression

Abstract:

The hot compressive deformation behavior of the superalloy was investigated at the temperature range from 1050 to 1140 and strain rate range from 0.01 to 10s^-1 on Gleeble-1500 thermal simulator. Utilizing hyperbolic sine function and introducing the strain with 4th order polynomial fitting, the constitutive equations of flow stress of spray-forming FGH95 superalloy at high temperature were established. The results show that during the hot compression deformation of the superalloy, the characteristics of dynamic softening were observed, and flow stresses decrease with increasing temperature and decreasing strain rate. The flow stress of the superalloy predicted by the proposed models with 4th order polynomial fit agree with the experimental value well, and the average relative error is 3.64%.