Development of High High Chromium Steel Tube Steel by Converter-Bloom Continuous Casting Process

Liang Chen; Tian Ming Chen; Yong Chen; Sen Xiang Yang; Qing Chun Li; Jian Hua Zeng

doi:10.4028/www.scientific.net/AMR.557-559.1257

Paper Titles

Research on the Cutting Properties of SiC/Cu Composite
p.1239

Analysis of Multiple Open Hot Die Forging for a General Cylinder Based on Numerical Simulation
p.1243

Ag Behaviors of Ag-Al Alloy Annealed in Air Atmosphere
p.1247

Determination of Multiple Heat Flux at the Metal-Mold Interface during Casting Solidification
p.1251

Development of High High Chromium Steel Tube Steel by Converter-Bloom Continuous Casting Process
p.1257

Study on the Surporting Mechanism of Precision Turning Process of Big-Diameter Length Rate Shaft by the Top
p.1263

Mechanical Behavior of Overlap-Welded of Dissimilar Steels (Structural-Stainless) under Monotonic Load
p.1268

Effect of Heat Input on Microstructure and Hardness of SKD 61 Hot Work Tool Steel Using Gas Metal Arc Welding
p.1275

Effect of Annealing Temperature on the Transformation Temperature and Texture of Ni₄₇Ti₄₄Nb₉ Cold-Rolled Plate
p.1281

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 557-559Development of High High Chromium Steel Tube Steel...

Development of High High Chromium Steel Tube Steel by Converter-Bloom Continuous Casting Process

Abstract:

In consideration of the composition characteristics and quality requirements of L80-3Cr high chromium Steel, the reasonable alloying system, temperature system and key technologies in continuous casting process are employed in the development of a full-line operation of LD-LF-RH-Bloom continuous casting on steelmaking with semi-steel, which meets the economic production of steel has been realized. The industrial tests show that the average effective rate of Cr is 98.2% in smelting process, and Cr content in steel products is consistent. T[O] content of rolled products is ranged from 10×10-6 to 16×10-6 with an average content of 13.5×10-6. Various inclusions of the products are no more than 1.0 level. There is good surface quality and internal quality of rolled products.