Numerical Simulation of Gradient Heat Treatment Process of Cylinder Welding Component of 30Si2MnCrMoV Steel

Abstract:

The finite element analysis method was applied to simulate the gradient field heat treatment process of a cylinder welding component of 30Si2MnCrMoV steel by software ANSYS. In the heat treatment process，the distribution of temperature field, the variation curve of residual stress with time，the distribution of residual stress along the axial direction of cylinder, and the axial and radial deformation of the specimen were calculated and the influences of partial heating area on the distribution of temperature and residual stress were analyzed. The calculating results show that the temperature in the weld metal zone and heat affected zone of welding specimens may exceed the phase transformation points during the gradient heat temperature. The residual stress and the radial deformation in the weld metal zone were greater than those in the matrix zone. The final deformation of specimen was along the axial direction. With the increase of partial heating area, the phase transformation area was increased and the residual stress was reduced effectively.

• Periodical: Advanced Materials Research (Volume 664)
• Pages: 990-995
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.664.990
• Online since: February 2013
• Authors: Q. Wang, W.L. Gu, D.L. Sun, X.L. Han, M.Y. Xue
• Keywords: Heat Treatment, Mechanical Property, Microstructure, Steel

References

[1] Y.H. Liu, B.H. Xie. Manufacturing Technology Research. Vol. 8(2009), p.28.

[2] Z.G. Yang, S.X. Li, Y.B. Liu. Int. J. Fatigue. Vol. 30(2008), p.1016.

[3] Q. Ji. Tianjin University Doctoral Dissertation, (2008).

[4] S.J. Lee, Y.K. Lee, Acta Materialia. Vol. 56(2008), p.1482.

[5] D.J. Su, J. Chen. Die Technology. Vol. 6(2006), p.54.

[6] Z. Liu, Z.J. Wu, et al. Numerical Simulation of Heat Treatment［M］. Science Press, Beijing, (1996).

[7] H.P. Li, G.Q. Zhao, L.F. He. Applied Mathematical Modeling, Vol. 33(2009), p.329.

[8] D.T. Wu, Z.D. Zou, et al. Heat Treatment Technology of Materials, Vol. 8(2009), p.121.