The Study of Brush Plating Process on Polyamide Engineering Plastics Surface

Jian Ren Wang; Yu Feng Zhang; Zhi Jun Gao

doi:10.4028/www.scientific.net/AMR.998-999.132

Paper Titles

The Investigation of Microstructure Silicon NH₃ Gas Sensors Based on Polyaniline Nano-Thin Films
p.115

The Structure and Electrical Property of sp² Rich Carbon Films by Magnetron Sputtering
p.120

Theoretical Investigation on the Role of Amine Bases in Stabilizing the Key Intermediate of Proline Enamine Carboxylate in Proline-Catalyzed Asymmetric Reactions
p.124

Well-Defined BaWO₄:Dy³⁺ Luminescent Materials: Hydrothermal Synthesis and Luminescence Properties
p.128

The Study of Brush Plating Process on Polyamide Engineering Plastics Surface
p.132

Research on Preparation and Properties of Textile Materials Deposited with Nanostructured Titanium Oxide
p.136

Ionization Cross Sections by Electron Impact for Single Ionization from the Atomic Ground State
p.140

Determination of Vitamin C Content in Brown Rice by Capillary Zone Electrophoresis
p.147

In Vitro and In Vivo Antitumor Efficacy of Curcumol Nanosuspension against H22 Tumor
p.151

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 998-999The Study of Brush Plating Process on Polyamide...

The Study of Brush Plating Process on Polyamide Engineering Plastics Surface

Abstract:

The oxidation polymerization simplifies the brush plating process, by which a conductive polymer film is formed on Polyamide Engineering Plastics surface before direct brush plating. In the article, analysis is made on the various process parameters and the influence of the brush plating solution composition on deposition rate . And discussion has been done on the polyamide engineering plastics brush plating process , which includes three phases, namely preprocess, catalysis and brush-plating. the demand on brush-plating process is as following: The workpiece is connected to the positive; the working voltage is 14 V; the movement speed of the brush is from 0.04 m/s to 0.06 m/s; the temperature of brush-plating solution should remains at 80 °C; PH value is between 4.3 to 4.5.The test consequence shows that there are many advantages of brush-plating nickel-phosphorus alloy on the polyamide engineering plastics surface such as simple operating , brush-plating layer with high strength, no stripping and no cracks,and high abrasive resistance, all of which have greatly extended the life of polyamide engineering plastics service.