Fabrication and Evaluation of Arrayed Needle-Like TiO2 Particle – Transparent Resin Composite Films

Shin Ichi Kikitsu; Takaaki Otsuka; Hidetoshi Miyazaki; Hisao Suzuki; Toshitaka Ota

doi:10.4028/www.scientific.net/KEM.484.177

Paper Titles

Characterization of Thermal Properties of Micro-Sized Ceramic Powders for APS Deposition of Ceramic Layers
p.152

Optimization of Alumina Slurry Properties and Drying Conditions in the Spray Drying Process and Characterization of Corresponding Coating Fabricated by Atmospheric Plasma Spray
p.158

Fabrication of AlN/Al₂O₃ Coatings via Atmospheric Reactive Plasma Nitriding of Al₂O₃ Powders
p.166

Effect of NH₃ Atmosphere on Preparation of Al₂O₃-AlN Composite Film by Laser CVD
p.172

Fabrication and Evaluation of Arrayed Needle-Like TiO₂ Particle – Transparent Resin Composite Films
p.177

Ternary Phase Relation on Preparation of YBa₂Cu₃O_7-δ Films by Laser CVD
p.183

Preparation of α-Al₂O₃/TiN Multilayer Coating on Ti(C,N)-Based Cermet by Laser CVD
p.188

Microelectronics Package Design Using Experimentally-Validated Modeling and Simulation
p.192

Hydroxyapatite Nano-Barium-Strontium-Titaniumoxide Composites
p.204

HomeKey Engineering MaterialsKey Engineering Materials Vol. 484Fabrication and Evaluation of Arrayed Needle-Like...

Fabrication and Evaluation of Arrayed Needle-Like TiO₂ Particle – Transparent Resin Composite Films

Abstract:

Needle-like TiO2-resin composite films were fabricated using needle-like TiO2 particle filler and urethane matrix. The needle-like TiO2 particles in the composite film were arrayed completely under the fabrication condition of applying AC bias of 10 volt with 0.1 Hz for 4 hr, and the transmittance of the resulting composite film showed angularly dependence. The needle-like TiO2 particles in the composite were oriented quickly by a larger applying bias. Furthermore, increase of the mixing ratio of TiO2 particles in the composite film caused increasing an angularly dependence of the transmittance of the composites.