Development of a New Ecological Lubrication System for Sheet Metal Forming Based on CO₂ in Liquid

Abstract:

Ecological aims and political requirements today are increasing demands on lubricants in sheet metal forming and their impact on environment. For that reason, metal forming industry wants to reduce the amount of lubricants containing polluting additives with a long-term goal of avoiding lubrication entirely. Additionally, dry metal forming will reduce the cleaning steps after the forming operation. This paper shows a new tribological system in which lubrication is replaced by CO₂ in a liquid state. Here, CO₂ is expanding directly into contact area between workpiece and tool surface and changes its state from gas to solid. The combination of this particular dry ice as well as the pressure of approximately 57 atm affects resulting friction coefficient significantly. After forming operation, CO₂ medium vaporizes and a dry component can be used immediately for the next process steps. In this case, the lubricant is applied directly into the contact area. Therefore, laser drilled micro holes are located in the contact area of the tool. Very first gained experimental results disclose such feasibility, the effects and the potential of this new lubrication system at that moment is based on strip draw tests. Different numbers of micro holes are examined to support blank holder pressure ranging between 5 MPa and 6 MPa. In this investigation a mild strength steel DC04 is used as sheet material. This knowledge is aimed to be used for further investigation and later transfer into real deep and stretch forming processes.

• Periodical: Key Engineering Materials (Volumes 651-653)
• Pages: 480-485
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.651-653.480
• Online since: July 2015
• Authors: Markus Singer*, Mathias Liewald, Anne Feuer
• Keywords: Dry Forming, Friction, Lubrication System

References

[1] Gesellschaft für Tribologie (Hrsg.): Tribologie – Verschleiß, Reibung, Definitionen, Begriffe, Prüfung. GfT-Arbeitsblatt 7, (2002).

[2] R. Span, W. Wagner: A New Equation of State for Carbon Dioxide Covering the Fluid Region from the Triple-Point Temperature to 1100 K at Pressures up to 800 MPa, J. Phys. Chem. Ref. Data, 25(6) (1996), 1509 – 1596.

DOI: 10.1063/1.555991

[3] F. Vollertsen, F. Schmidt, Dry Metal Forming: Definition, Chances and Challenges, International Journal of precision engineering and manufacturing - green technology, Vol.1, No. 1 (2014) 1-4.

DOI: 10.1007/s40684-014-0009-0

[4] N. Bay, A. Azushima, P. Groche: Environmentally benign tribo-systems for metal forming, CIRP Annals – Manufacturing Technology 59 (2012), 760 – 780.

DOI: 10.1016/j.cirp.2010.05.007

[5] Information on: http://pdf.directindustry.de/pdf/nanofocus/nanofocus-technologiebroschure/25059-351869.html (9 April 2014).

[6] E. Schulz, V. Piotrowski, M. Clauss: Dietary Abrasiveness Is Associated with variability of microwear and dental surface texture in rabbits, PLoS One, 8/2 (2013).

DOI: 10.1371/journal.pone.0056167

[7] M. Liewald, S. Wagner, D. Becker, New approaches on Coulomb's friction model for anisotropic sheet metal forming applications, Proceedings of the 9th ESAFORM Conference on Material Forming (2006).

[8] H. Berns, W. Theissen, Eisenwerkstoffe – Stahl und Gusseisen, Springer, Berlin Heidelberg, (2013).